Instructions (VR-SR)
Step 1: Verify wall surface
Verify wood thickness is at least 1/2” thick.
Step 2: Mark mounting hole locations
Mark the center-point of the rst rail and, using a level to ensure
the marks are on the same horizontal plane, mark the center-
point of the second rail 2 inches (51mm) away (gure a).
Step 3: Drill the anchor holes
Drill a 5/32 inch (4mm) pilot hole at the marked hole locations
(gure b). If you do not hit a stud or solid wood, you will need
to use Vino Series Stemware Rack with Collars (VRC-SR).
Step 4: Install the Wood Studs
If supplied, use the hex key to drive the Machine/Lag Studs into
the holes until the coarse threads of the lag screw are no longer
visible.
Otherwise, thread 2 nuts onto the ne threaded end of one
Machine/Lag Studs and using two 10mm wrenches, tighten
the nuts against one another (gure c). With the nuts tightened
against each other, use one wrench on the outer nut and screw
the lag end into the pilot hole in the wall.
Thread the bolt into the wall until the coarse threads of the lag
screw end are no longer visible, leaving just the ner threads
exposed (gure d). Again using 2 wrenches, loosen the nuts
and remove them from the ne threaded end of the stud.
3"
3"
2 1/2"
2”
3.25”
gure a
gure b
gure c
gure d
