Vintage view W Series User manual

Le Rustique
Installation Instructions for W Series Le Rustique (LR1)
• 1 Base Strip
• 1 Neck Strip
• 2 Decorative Scrolls
• 1 Lower Cross Rail
• 1 Upper Cross Rail
• 8 Spiral Anchors with Screws
• Phillips head screw driver
• Level
• Pencil
• Tape Measure
Parts List Required Tools
1. Mark the hole locations for the rst
strip – Hold either the neck or base strip of the rack
in place against the wall a minimum of 2-1/4 inches
away from any corners or protusions. Ensure that the
rack is vertical using a level and mark the 4 hole
locations with a pencil and set the strip aside.
Figure A
2. Mark the hole locations for the second
strip – Using the Upper Cross Rail as a guide, align
a mounting hole with one of the 4 marked hole
locations from Step 1 and, using a level, make sure
that the Cross Rail is level at each position. Mark the
hole location for the second strip at the opposite end
of the Cross Rail
Figure B
3a. Install the anchors and secure the
rack – Using a Phillips Head Screw Driver, screw
the 8 spiral anchors into the wall at the marked hole
locations. Place the Upper Cross Rail (the at one)
behind the Base Strip, and align the mounting hole
on the Upper Cross Rail with the SECOND hole from
the top on the Base Strip. Fasten the Upper Cross Rail
and Base Strip to the wall, making sure to screw it
into the SECOND anchor from the top. With the top
of the rack secured, position the Lower Cross Rail (the
one with the slight bend at both ends) even with the
bottom of the rack and secure it in place with a screw.
3b. Carefully, slide the Neck Strip in place, over the
Upper Cross Rail and behind the Lower Cross Rail
then secure in place with 3 screws, as shown.
Figure C

Instructions
Maintenance and Care - Your W Series racks should be regularly inspected for secure wall attachment. Should
any fastener be found to be loose, tighten it appropriately. If the wall surface shows any signs of breakage,
discontinue use immediately until such time as the wall may be adequately repaired. W Series racks may be
cleaned with a damp cloth and mild dish soap – avoid vinegar, harsh chemicals such as bleach or degreasing
agents, abrasive cleaners, abrasive pads or steel wool.
4. Install the decorative scrolls - Note: If
stacking more than one rack, refer to Option 1 on the
reverse of this page. Slide a Decorative Scroll into
place, at the top of the Base Strip and secure in
place with a screw, as shown. (The Upper Cross rail
screw may need to be loosened to perform this step
so be sure to re-tighten the screw fully). Repeat the
process with the second scroll on the Neck Strip.
Figure E
Figure D
5. Complete - You’re done! Load with wine and
enjoy!
Option 1
Option 1 - If stacking multiple units, do not install
the decorative scrolls in the lower units. Instead, slide
the bottoms of the upper racks into the gap behind
the top of the lower rack. For the upper units, the
Lower Cross Rail is not used and may be discarded.