VIRTUFIT Heart Rate Transmitter User manual

EN
VirtuFit Heart Rate Transmitter 1
User manual
Heart Rate Transmitter
EN
Read these instructions carefully before using the VirtuFit Heart Rate Transmitter. You receive important
information about the use and safety of your VirtuFit Heart Rate Transmitter.
Note the following precautions for using the VirtuFit Heart Rate Transmitter.
– With the VirtuFit Heart Rate Transmitter your heart rate signals are transmitted wirelessly to the
recipient terminal such as a wrist watch or exercise computer through which the heart rate will be
read turn into. This measurement is accurate and good for anti-interference.
– The low frequency applies to transmission and environmentally friendly materials.
– The water-resistant design will protect against sweat during your exercise.
WARNING:
Before beginning any exercise program consult your physician. This is especially important for people
who are over 35 years old or who have pre-existing health problems. Read all instructions before using
any fitness equipment.
ATTENTION

EN VirtuFit Heart Rate Transmitter
2
USER MANUAL
EN
– The transmission frequency is 5.3K HZ and is compatible with POLAR.
– The transmission distance is 90 cm.
– Battery: 1pcs CR2032. The battery runtime is 10 months when used for 1 hour per day.
Wearing the VirtuFit Heart Rate Transmitter
Insert one end of Elastic Belt (E) into the hole of Connection Belt (B), then turn around the Elastic Belt (E)
end to right fit the hole and press the connection part. Wear the VirtuFit Heart Rate Transmitter with Sensor
(C) closely touch your chest. Then insert the other end of Elastic Belt (E) into the other hole of Connection
Belt (B). Adjust the Elastic Belt to tightly wear the belt. Please note that the Sensor (A) should closely touch
the right and left ventricle skin.
Check the following to see if you wear the VirtuFit Heart Rate Transmitter properly
– The transmitter runs parallel to the floor.
– Both sensors closely touch the skin of the left and right ventricle.
Replace the battery
Unscrew the battery compartment (D), remove the cover and replace the battery with the “+” sign facing
up. Seal the battery compartment (D) again with the cover and tighten. Use a suitable sized battery.
NOTE
–The Virtufit Heart Rate Transmitter can measure heart rate inaccurately if the skin is too dry. Then
you may moisture the Sensor (A) and test the heart rate again.
–The Sensor (A) may not detect the heart rate signal if the chest hair is too dense. Please wear the
VirtuFit Heart Rate Transmitter away dense hair if possible.
CHARACTERISTICS
BATTERY
USE HEART RATE TRANSMITTER
ASensor
BConnection Belt
CTransmitter
DBattery Compartment
EElastic Belt