VirtuReal Cycling PraxTour PraxFit User manual

User Manual
01
STEP
03
04
05
STEP
STEP
02
STEP
STEP
Chose between PraxFit, PraxSpin or
PraxFilm
PraxFit: based on movement (RPM)
PraxSpin: based on average speed
PraxFilm: based on fixed speed
Select a route / movie
Start cycling
The route appears
Stop cycling to pause your activity
The pause screen appears
Select number 1 - 6 to jump to a
different starting point
Explanation of icons:
To continue your activity, start
pedaling again
The locator appears
Scroll the green bar to move the (Prax)Film
RPM: Rotation per minute
Locator: Jump to a different point
Volume: Increase (+) and decrease (-)
Speed: Kilometres per hour (PraxSpin)
In case of no connection:
Check if the sensor is fastened on the crank
Try a second time
Deselect and select the sensor again
Check battery percentage in BLE settings
Reset the sensor (remove the battery)
Replace the battery in case below 15%
Restart computer (off – on)
Chose PraxSpin
Contact your dealer or reach us at [email protected]
In case the problem is not solved:
Copyright © Praxtour
PraxFit - PraxSpin - PraxFilm

User Manual
01
Cadence sensor
02
STEP
03
STEP
STEP
04
05
STEP
STEP
Fasten the cadence sensor on the
crank
Connecting the BlueTooth Cadence
sensor (installation)
Go to Settings, and select BLE settings
Activate the cadence sensor by
pedaling
As soon as the cadense sensor is
successfully connected you will
receive a notification
Copyright © Praxtour
Select the cadence sensor
Signal strength should be "Good" at
minimum
Wait for the battery signal
Select settings again, and select Home
In case of no connection:
Check if the sensor is fastened on the crank
Try a second time
Deselect and select the sensor again
Check battery percentage in BLE settings
Reset the sensor (remove the battery)
Replace the battery in case below 15%
Restart computer (off – on)
Chose PraxSpin
Contact your dealer or reach us at [email protected]
In case the problem is not solved: