Vision grills RX-K18F1M4 Manual

ENGLISH
SET UP
Step 1: Cart & Grill Assembly
Model #s RX-K18F1M4 / RX-W19D1L5 / Sanibel
• Unpack cabinet cart from
packaging. (Step 1a)
• Wheels, door and posts are
preassembled.
SIGNATURE SERIES GRANDE
STEP 1b
• Insert back side poles over back
posts of cart (Step 1b). Make
sure felt stoppers are facing
inward and shelf brackets are
facing outward.
• Line up holes in back side pole
with spring loaded pin on back
post and push down until they
snap into place.
• Take all parts out of grill before lifting. The Kamado grill
is heavy and will require two people to lift and guide
onto cart (Step 1c).
STEP 1c
Parts for Assembly:
2 pcs. - Back Side Poles
A
B
C
I
J
H
K
L
2 pcs. - Front Side Poles
M
E
2 pcs. - Side Shelves
N
1 pc. - Pre-Assembled
Cart
1 pc. - Charcoal Grate
1 pc. - Fire Bowl
1 pc. - Wood Handle
1 pc. - Top Vent
Tools Included:
T-Handle Wrench Flat WrenchBox Wrench:
For shelves assembly
D
Grate Lifting Tool
1 pc. - Kamado Grill
Cooking Stone &
Bracket
Grill Light • Be sure ProZoneTM
is centered between
two front posts and
the back of the grill
is resting against
the two back leg felt
stoppers.
STEP 1a
F
1 pc. -
Top Flip Grate
G
1 pc. -
Cast Iron Grate
G*
1 pc. -
Bottom Flip Grate
*Sanibel Only

Step 4: Lava Stone & Bracket Assembly
• Open grill and take off grill grates to expose
re bowl.
• Spread bracket so it makes an “X” shape and
lower into re bowl, allowing the bracket to
rest on edge of re bowl.
• Lower Lava Stone onto the bracket.
STEP 4
Step 3: Install Grill Light
• Remove nut and washer from the rst
bolt on right side of bottom banding.
•
Slide exible light bracket over bolt, then
replace washer and bolt and tighten
(Step 3a) and
insert exible light into
bracket and tighten knob (Step 3b).
STEP 3a STEP 3b
Step 2: Handle and Side Shelf Mounting
• To assemble handle, remove nuts and washers from bolts
welded on the top banding opposite the hinge.
• Remove paper washers and attach handle bracket over studs.
On each stud place a at washer and an acorn nut, then tighten
(Step 2).
•
Mount side shelves by inserting the shelf rod into the shelf bracket.
Tilting the shelf up slightly and sliding in or out allows you to deploy
the shelves.
STEP 2
STEP 1d
•(Step 1d:) Lower re bowl into grill with the ash drawer
opening lined up with the opening in the main ceramic
body. Place cast iron grate with attached starter pocket
into re bowl. Align tabs of starter pocket with electric
starter port in re bowl.
•Insert front side poles over front posts. Snap post into
place by lining up holes in poles with spring loaded pins
on each post.
Step 1 (continued): Grill Assembly

STEP 7b
• Place cooking grates onto grill with hinged section
facing towards front of grill.
• Close lid and press top vent onto grill with calibrations
facing the front (Step 5).
STEP 7a Step 7: Ash Drawer Usage
• Once grill is cool, it is safe to remove ash from Ash Drawer.
• (Step 7a) Using bottom knob on ProZoneTM, lift slightly and (Step 7b)
pull drawer out.
• Once ashes are emptied, reinstall by pushing ProZoneTM back into
grill body until it drops down back into place.
WARNING: ALWAYS WAIT FOR ASHES TO COOL BEFORE REMOVING
ASH DRAWER. NEVER PULL OUT ASH DRAWER WHILE GRILL IS HOT.
Step 6: Using the Electric Starter
• Place required amount of charcoal inside re bowl and
completely open bottom and top vents to maximize air ow.
• Flip open electric starter door and insert electric starter as
far in as possible. Plug in electric starter.
• Wait until edges of charcoal turn white and ames are
licking the mound of charcoal. On average it takes 8-12
minutes to start charcoal.
• Unplug starter and remove from ProZoneTM. Be careful when removing electric starter, the
element will be very hot. After use, let element rest on support and cool completely away
from children and pets.
NOTE: Do not plug the electric starter in while it is raining unless you’re in a safe and securely
covered area.
Step 5: Complete Assembly
Long-Term Maintenance
• Cover your grill when not in use to extend life and maintain appearance.
• When moving grill, always pull by the back hinge.
STEP 5
Step 8: Removing Cast Iron Grate
• Use provided Grate Removal Tool to lift out Cast Iron
Grate by centering the prongs of the tool in between
the center grate bars closest to the Vision Grills logo.
• When prongs are pushed all the way forward, lean
Tool back against grate and lift up. Use caution, Cast
Iron Grate is heavy.

ENGLISH
Vision Grills, LLC • 1531 Fairview, Suite B, St. Louis, MO 63132 • 877.917.4273 • www.visiongrills.com
Visit
www.visiongrills.com/register
to register your grill.
SIGNATURE SERIES
GRANDE
PARTS
PART NAMES PART NUMBERS
1 Cast Iron Top Vent
Stainless Steel Top Vent
1.1 Bakelite Tab
1.2 Smoker Knob
2 Ceramic Dome Lid
2.1 Thermometer
3 Top Ring Assembly
4 Ceramic Dome Bottom
5 Bottom Ring Assembly
6 Cast Iron Cooking Grate
7 Charcoal Grate
8 Electric Starter Pocket
9 Fire Bowl
10 Top Cooking Grate
11 Shock Absorber Assembly
12 Cabinet Cart Assembly, Powder Coat
Cabinet Cart Assembly, Stainless Steel
13 Wood Shelves, Slatted, Dark (x2)
Solid Stainless Steel Shelves (x2)
14 Handle (with nuts & washers)
15 Ash Drawer Body, Powder Coat
Ash Drawer Body, Stainless Steel
15.1 Starter Port Flipper Door, Powder Coat
Starter Port Flipper Door, Stainless Steel
16 Back Side Pole, Powder Coat (x2)
Back Side Pole, Stainless Steel (x2)
17 Felt Gasket
18 Rubber Wheels (x2) Standard
19 Rubber Wheels (x2) Locking
20 Front Side Pole, Powder Coat (x2)
Front Side Pole, Stainless Steel (x2)
21 Bottom Cooking Grate, Stainless Steel
22 Grill Cover
23 Lava Stone
24 SS Stone Bracket
25 Electric Starter
26 Flexible Grill Light, White
Flexible Grill Light, Black
VGC TV-CAS-X
VGC TV-SSS-X
VGC TV-CAS-T
VGC TV-CAS-SK
VGC CDLSS-1-X
VGC SSIT
VGC RA1-X
VGC SSDB-X
VGC RA2-X
VGC CGB-X
VGC CG-1-X
VGC ESP-1
VGC FB-1X
VGC CGT-X
VGC AC-X
VGC CCPC-X
VGC CCSS-X
VGC WS-SD-X
VGC SSS-X
VGC HDLSS-X
VGC ADB-PC
VGC ADB-SS
VGC ADB-PCFD
VGC ADB-SSFD
VGC CCBP-PC-X
VGC CCBP-SS-X
VGC FLT-X
VGC WHLS-X
VGC WHL-L-X
VGC CCFP-PC-X
VGC CCFP-SS-X
VGC CGB-X
VGC GC-X
VGK-101R-X
VGK-BRACKET-X
VGK-ELEC
VGK-FGL-W
VGK-FGL-K
1*
2.1
2
3
14
10
7
5
13*
415.1*
6**
1818
22
**
17
11
1.1
15*
13*
1.2
8
19
19
23
**
24 ** 25 **
9
* Part Material & Style may vary based on Model
16* 16*
12*
20* 20*
26 **
Model #s RX-K18F1M4 / RX-W19D1L5 / Sanibel
*Sanibel Only
21
** Not included in all Grill packages