Visionhitech VC59AHD User manual
㪁㩷
QUICK INSTALLATION GUIDE
AHD Box Camera
◆
Special features
DEAR CUSTOMERS!
By selecting this product, you have decided to use a professional
device that guarantees highest quality and reliability. We would like to
thank you very much for your confidence and kindly ask you to read
the following instructions carefully before installation and operation in
order to take full advantage of all quality features regarding this
product.
The lighting flash with an arrowhead symbol, within an
equilateral triangle is intended to alert the user to the
presence of non-insulated dangerous voltage within the
product’s enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
INFORMATION
This equipment has been tested and found to comply with limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at its own expense.
WARNING
Changes or modifications not expressly approved by the manufacturer
could void the user’s authority to operate the equipment.
CAUTION – To prevent electric shock and risk of the fire hazards
•
Do NOT use power source other than that specified.
•
Do NOT expose this appliance to rain or moisture.
This installation should be made by a qualified service person and should conform to all local codes.
1. Precautions
set up the camera correctly and to obtain the best picture quality.
and service application.
personnel according to local safety regulations.
disconnect the camera from power supply and have it checked by
To avoid electric shock, never remove the screws or covers. There
are no parts inside that need maintenance by the user.
All maintenance should be carried out by qualified personnel.
best picture quality all the time.
Be careful not to be stained by fingerprint.
area.
or external shock during the process of transportation or handling.
2. Limitation of liability
either express or implied, including but not limited to, the implied
warranties of merchantability, fitness for any particular purpose, or
This publication could include technical inaccuracies or typographical
errors.
Changes are added to the information herein, at any time, for the
improvements of this publication and / or the corresponding product(s).
3. Disclaimer of warranty
replacement or reasonable maintenance of the product, for the cases,
including but not limited to below :
(1) Any damage and loss, including without limitation, direct or indirect,
special, consequential or exemplary, arising out of or relating to the
product;
negligent operation of the user;
the user;
due to any reason or cause including any failure or problem of the
product;
(5) Any problem, consequential inconvenience, or loss or damage,
arising out of the system combined by the devices of third party.
(6) Any claim or action for damages, brought by any person or
picture, including saved data, for some reason, becomes public or
is used for the purpose other than surveillance.
Camera x 1
guide x 1
4. Package
5.Name and function of each part
5‐1. Right side
5-2. Front / Bottom side
Fixture can be separated and attached on the bottom side as well.
bracket.
Using screws of more than 5mm depth can do a serious damage to the
inside of this camera.
the camera.
Take off the protection cover.
5.Name and function of each part
5-3. Rear side
ྙG
ྚ
ྛ
Connect coaxial cable for composite video signal out.
ྜAHD output (BNC Female)
Connect coaxial cable for AHD signal video signal out.
ྜྷDay & Night Out port
this port.
ྞ
Connect to the power source.
6. Installation
㪚㪄㪤㫆㫌㫅㫋㩷㪘㪻㪸㫇㫋㫆㫉㩷㫏㩷㪈
x 1
Auto IRIS Lens Connector
2- 1/4"-20UNC
2- 1/4"-20UNC
Protection Cover
CAUTION
CAUTION
503&%6$&5)&3*4,0'&-&$53-$4)0$,
%0/053&.07&5)&$07&303#"$,
/064&34&37*$&"#-&1"354*/4*%&
3&'&34&37*$*/(5026"-*'*&%1&340//&-
6-1. Lens
order to get the best picture quality. Use of DC auto iris lens is
recommended to achieve the best results for operating this product
effectively.
ō
G
Caution
Clean dirt or water drops with soft cloth in order to avoid the picture
blooming or reflection.
ō
G
Note
To get the best image quality, please use recommended lenses from
the manufacturer or camera supplier.
6-2. When using an auto iris lens (DC-drive)
12VDC, 12VDC / 24VAC (Option)
Pin No.
Lens
DC
Damping -
Damping +
Drive +
Drive -
QUICKINSTALLATION GUIDE
AHDBox Camera
◆
Special features
12VDC,12VDC / 24VAC (Option) ⴘ
ⴙ
ⴚ ⴛ
ⴝ
ⴜ
POWER
CVBS AHD
12VDC
GND D/N
6. Installation
lens according to the pin configuration as shown in the drawing.
4. Assemble the lens.
· Fix the lens by turning it clockwise.
6-3. When using a C-mount Lens
adaptor
6-4. When using a CS-Mount Lens
lens by turning it clockwise.
camera depending on the type of selected lens.
6. Installation
iris socket.
㪣㪼㫅㫊㩷㪸㪻㫁㫌㫊㫋㫄㪼㫅㫋
Tele-Wide
Near-Far
6-5. Application of AHD 2.0 output
6. Installation 8. Troubleshooting
9. Specifications
12VDC camera
regulated power supply.
12VDC / 24VAC Dual Power camera
(Option)
6-6. Power
6-8. Setting up the menu
the camera.
2 seconds.
on the monitor.
wish to activate by using the
The cursor can be moved up or
point to the function you wish to operate.
66
64
7. Dimension (mm)
Before asking for repairs, refer to the following table.
")%
Coaxial Cable AHD DVR
6-7. OSD Manual for functions control
SETUP
LENS DC ANUA
EXPOSURE HUTTR
D-WDR
AC
DFO N-U BRHTN RTURN
BACKLIGHT BC HBC OFF
WHITE BAL ATW
AWC tT AWB OUTDOOR NDOOR ANUA
DAY&NIGHT AUTO XT B/W COOR
NR 2DNR 3DNR RTURN
SPECIAL CA TT
ANUA
D-FFCT
DFCT OTON RVAC RTURN
ADJUST HARN
OUT. OD ONTOR C VDO.OUT RTURN
EXIT AV&ND NOT AV RT
Problems
Troubleshooting
Nothing appears
on the screen.
lease check that the power cord and line connection
between the camera and monitor are fixed properly.
The dim image
on the screen.
s lens stained with dirt? Clean your lens with soft,
clean cloth.
et the monitor to proper condition.
f the camera is exposed to too strong light, change the
camera position.
lease check if the power supply is within the
specification & cables. (Due to the voltage drop with
distance and gauges, D will light poor)
The dark image
on the screen
Adust the contrast feature of the monitor.
f there is an intermediate device, set the
5 /
The camera is
not working
properly, and
the body of the
camera is hot.
lease check if the power supply is regulated and is
within the standard requirement of the products.
Color is not
correct.
lease check the setting of White Balance setup.
The screen is
flickering.
sunlight or fluorescent light.
MODEL AHD Box Camera
xDC12V xDC12V / AC24V
mage sensor 2 egapixel 2." ON progressive scan CO ensor
H. Resolution 11TV ines
Total ixel 152(H) x 1116(V) 2.1egapixel
ffective ixels 144(H) x 114(V) 2.14egapixel
canning system rogressive scan
Video output AHD : 12 x 1 3fps, CVB : 6H
/N ratio ore than 52dB (AC OFF)
OSD
RVAC A ON / OFF (4 one)
OTON Detection ON / OFF (4 one)
N.A ON / OFF
RROR OFF / RROR / V-F / ROTAT
FRZ ON / OFF
in. llumination .5ux
White Balance AWB / ATW / AWC tT / NDOOR / OUTDOOR / ANUA
(2, ~ 2,)
hutter peed AUTO / ANUA (1/3 ~ 1/5, NTC, 1/25 ~ 1/5, A)
ens-up AUTO / OFF (electable imit x2 ~ x3)
BC OFF / BC / HBC
mart R OFF / ON
ain Control ~ 15
2D/3D DNR OFF / OW / DD / HH
DA / NHT AUTO / COOR / BAC & WHT / XT
HARN ~ 1
N hading ON / OFF
DFO ON / OFF
anguage
LENS
ens C/C ount, anual
ens Control DC R / anual ens ode elect
ELECTRICAL
ower ource 12VDC 12VDC, 24VAC
Operating current 15mA 12VDC : 1mA
24VAC : 5mA
Operating
Temperature -1°C ~ 5°C
Operating Humidity %RH ~ %RH
easurement(mm) 66(W) x 64(H) x 13.()
Weight(Approx. g) 55 56
POWER
CVBS AHD
12VDC
GND D/N
POWER
CVBS AHD
12VDC
GND D/N
Other Visionhitech Digital Camera manuals
