Vivitar VF60016BT User manual

VF60016BT
USER’S MANUAL
Bluetooth Speaker
RECHARGEABLE
BATTERY
UP TO 4 HOURS
PLAYTIME †

Important Safety Precautions
When using your Vivitar Boombox Wireless Speaker, basic safety precautions should always be followed,
including the following:
1. READ ALL INSTRUCTIONS BEFORE USING YOUR SPEAKER.
2. Do not use your speaker near water. Clean using a soft cloth or paper towel.
3. Do not place your speaker on any wet surfaces.
6. Always press all buttons or switches carefully. Do not manhandle your speaker.
7. Do not use in extremely dry environments, as this can lead to static discharge during usage.
8. Do not expose your speaker to temperatures above 102°F/ 40°C. Keep out of direct sunlight.
service.
10. Do not drop, throw, or expose your speaker to excessive trauma.
11. Your speaker is not intended for commercial use.
13. Unplug this device when not in use for long periods of time. Do not charge during lightning storms.
14. Please recycle or dispose of your speaker properly based on the laws and rules of your municipality. Contact
local recycling facilities and/or the manufacturer of your speaker for further information.
BATTERY WARNING:
-The device is equipped with an integrated lithium ion battery. The battery cannot be
replaced. Do not attempt to remove the battery from the device.
-Do not dispose of in re or expose to excessive heat.
-Do not crush, puncture, incinerate, or short circuit external contacts.
-Please recycle or dispose of the battery properly. Contact your local recycling
facilities and/or the manufacturer for further information.
CAUTION

Introduction
Thank you for purchasing your Vivitar Boombox Wireless Speaker, item VF60016BT. Your
speaker is compatible with most smartphones and Bluetooth. In order to get the best results
Package Contents
-Vivitar VF60016BT Boombox Wireless Speaker
-USB Charging Cable
-3.5mm AUX Cable
-User’s Manual with Warranty Information
Bluetooth Range: Up to 33 feet (10 meters)
Power Supply: 5V/ 500mA
Battery Type: 1200 mAh Lithium Ion Battery
Charge Time: Approximately 2-3 Hours
Play Time: Approximately 3-4 Hours**
***Applicable at 50% of maximum volume. Results will be lower when volume is higher.

A Quick Look
On/Off Switch
Auxiliary Port
Charging Port

Charging Your Speaker
Your speaker has a built-in, rechargeable lithium Ion battery. To avoid damage, do not attempt to
remove the battery. The full performance of the battery is only achieved after a few charging-dis-
1. Connect one end of the included USB charging cable to the charging port on your speaker.
Then plug the other end of the USB charging cable into a USB port on your computer or a
suitable power adapter in order to recharge the internal rechargeable battery.
2. When the battery is charging, the LED indicator light will turn red. The LED indicator light will
turn off when the battery is fully charged. Unplug when charging is complete.
NOTE: Overcharging could reduce the life of the battery. And a charged battery will lose its
capacity if it is not used on a regular basis.
Important!
To avoid a complete discharge of the battery, charge your speaker at least once every six
months.

Pairing Your Speaker with a Bluetooth Device
Your speaker can be paired with most Bluetooth devices including iPads, iPhones, and most
smartphones, and tablets. In order to pair your speaker with a device, follow the steps below:
1. Slide the On/Off Switch to the ON position in order to turn on your speaker. The LED
indicator light will turn blue and blink rapidly to indicate its in pairing mode.
2. Go into the Bluetooth settings screen on your phone. Connect “ VF60016BT” under
available devices.
3. Once paired, the LED indicator light will turn blue.

Using Your Speaker
1. Slide the On/Off Switch to the ON position in order to turn your speaker ON. If you have
already paired your speaker to your Bluetooth device, they will automatically remain paired each
time you power on your speaker.
3. To use your speaker with devices that are not Bluetooth enabled, plug one end of a standard
3.5mm audio cable into the Auxiliary Port on your speaker. Plug the other end into the
headphone jack on your audio device.
Note: You can adjust volume and playback settings on your phone or connected audio device.

Maintenance and Care
-Before using your speaker, inspect the ports to make sure that they are clear of dust and debris
before charging or inserting an AUX cable.
-Use a soft cloth to clean your speaker. Never use any harsh chemicals or detergents. Make sure
your speaker is dry before using.
-When your speaker is not in use, it should be stored in a cool, dry place.
-Never tug or yank on either USB charging cables or AUX cables while they are connected to
your speaker. Connect and disconnect these cables as carefully as possible.
-Never expose your speaker to high temperatures, extreme cold, high humidity or excessive
moisture or water.
-Please recycle or dispose of your speaker properly based on the laws and rules of your munici-
pality. Contact local recycling facilities and/or the manufacturer of your speaker for further
information.

FCC Statement
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.

Vivitar One Year Warranty
This warranty covers the original consumer purchaser only and is not transferable.
This warranty covers products that fail to function properly UNDER NORMAL USAGE, due to
defects in material or workmanship. Your product will be repaired or replaced at no charge for
parts or labor for a period of one year.
What Is Not Covered by Warranty
Damages or malfunctions not resulting from defects in material or workmanship and damages or
malfunctions from other than normal use, including but limited to, repair by unauthorized parties,
To Obtain Warranty Service and Troubleshooting Information:
Call 1-800-592-9541 in the U.S. or visit our website at www.vivitar.com.
To receive Warranty service along with the name and address of an authorized product service
center, the original consumer purchaser must contact us for problem determination and service
procedures. Proof of purchase in the form of a bill of sale or receipted invoice, evidencing that the
product is within the applicable Warranty period(s), MUST be presented in order to obtain the
requested service. It is your responsibility to properly package and send any defective products
along with a dated copy of proof of purchase, a written explanation of the problem, and a valid
return address to the authorized service center at your expense. Do not include any other items
or accessories with the defective product. Any products received by the authorized service
center that are not covered by warranty will be returned unrepaired.