3
ASSEMBLY STEPS
STEP 1
Place the desk sleeve (A) on the desktop at the desired location. Measure the space
between the underside of the desktop and the lower portion of the sleeve to determine the
required spacers (B) and washers (F) for mounting. Remove the desk sleeve (A) from the
desktop.
STEP 2
Install front end of the keyboard mount
to the desk sleeve using either the M5x8
bolts (D) or M6x8 bolts (E), depending
on the keyboard mount to be installed.
Tighten with a Phillips screwdriver.
STEP 3
Fit the desk sleeve (A) with keyboard
mount to the desktop. Drill 10mm deep
pilot holes in the desktop for the desk
sleeve and the rear end of the keyboard
mount using a 3mm (1/8”) drill bit.
STEP 4
Secure the desk sleeve (A) and keyboard
mount to the desk using M5x35 screws
(C) and previously counted spacers
and washers. Tighten with a Phillips
screwdriver.
M5x8 or M6x8
15X5.3X1.2
DESK
