Vivotek IP8131 User manual

EN - 1
English
Power off the Network Camera as
soon as smoke or unusual odors are
detected.
Keep the Network Camera away
from water. If the Network Camera
becomes wet, power off immediately.
Do not place the Network Camera
around heat sources, such as a
television or oven.
Refer to your user’s manual for the
operating temperature.
Keep the Network Camera away from
direct sunlight.
Do not place the Network Camera in
high humidity environments.
Warning Before Installation
Do not place the Network Camera on
unsteady surfaces.
Do not touch the Network Camera
during a lightning storm.
Do not disassemble the Network
Camera.
Do not drop the Network Camera.
Do not insert sharp or tiny objects
into the Network Camera.
Camera Stand
IP8130
Warranty Card
Screws
Quick Installation Guide
Power Adaptor (+12V, 1A)
Package Contents
1
Software CD
5
0
0
0
2
4
7
0
1
G
IP8131
Ethernet Cable

EN - 2
Physical Description
2
Front Panel
Status LED
Lens
Microphone
IP8130
IP8131
Microphone
IR LEDs
Status LED
Item LED status Description

1 Steady Red Power on and system boot
Red LED off Power off
2 Blink Green every 1 sec. Network connected
Steady Red Network failed
3 Blink Green, RED, and Orange
intermittently

4 Blink Orange every 0.15 sec. Restoring default
MicroSD/SDHC/
SDXC Card Slot
Lens

EN - 3
English
Back Panel The back panels are identical for both models.
Power Cord
Socket
Reset Button
Ethernet 10/100
RJ45 Socket
General I/O
Terminal Block
1 DI-
2 DI+
3 Audio GND
4 Audio Out
Audio out cable is user-supplied.

EN - 4
Network Deployment
4
1. If you have external devices such as sensors and alarms, make connections from
general I/O terminal block.
LAN Connection
POWER COLL I SIO N
LINK
RECEI VE
PARTITI O N
12345
3. Connect the supplied power cable from
the camera to a power outlet.
2. Connect the camera to a switch via
Ethernet cable.
Install Camera to Stand
3
Attach the camera to stand and orient the shooting angle. If preferred, use the included
screws to secure the the camera stand to a mounting surface.

EN - 5
English
MAC:0002D132C353
IP8130
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Pat. 6,930,709
1. Install “Installation Wizard 2” from the Software Utility directory on the software CD.
2. The program will conduct an analysis of your network environment. After your network is
analyzed, please click on the “Next” button to continue the program.
0002D132C353
00-02-D1-32-C3-53 192.168.5.151 IP8130
Installation
Wizard 2
Assigning an IP Address
5
2012/11/05 01:50:28
3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network
Cameras on the same LAN.
4. After a brief search, the main installer window will pop up. Double-click on the MAC
address that matches the one printed on the camera label or the serial number on the
package box label to open a browser management session with the Network Camera.
5. A browser session with the
Network Camera should
prompt as shown below.
6. You should be able to see live
video from your camera. You
may also install the 32-channel
recording software from the
software CD in a deployment
consisting of multiple cameras.
For its installation details,
please refer to its related docu-
ments.