Vizualogic HindSight Cadillac Escalade User manual

LCD Monitor &
CCD Color Camera
Cadillac Models
Cadillac Escalade–2001-2004
ESV–2003-2004
EXT–2001-2004
Installation Manual
Backup Monitor System
Fall 2003
1493 Bentley Drive • Corona, CA 92879 • 909-272-1996 • 800-624-7960 • Fax [phone]
www.vizualogic.com
Copyright © 2003 TMI Products, Inc.
All Rights Reserved
Corona, CA U.S.A.
060300
99-8019-004 10/03
Backup Monitor System

Control Box Installation
1. Locate suitable A/V Control Module mounting location
(i.e. center console).
2. Attach the A/V Control Module wires as follows:
Wire Color Connection
1. Red +12V Battery
2. Orange +12V Reverse Light
3. Black Ground
3. Secure the A/V Control Module using the provided screws.
Monitor Installation
1. Locate the driver’s side or passenger side
visor-clip mount. (Fig. 2)
2. Route the Monitor Cable from the headliner to
the A/V Control Module via the A-pillar.
3. Insert the Monitor Cable into the opening on
the back-side of the Monitor Housing.
4. Connect the Monitor Cable to the LCD Monitor.
5. Screw the LCD Monitor onto the Monitor
Housing using the (2) provided screws.
6. Loosen the visor-clip mount screw.
7. Secure the (2) Monitor Housing rear-hooks to the headliner. (Fig. 3)
8. Secure the (1) Monitor Housing front-hook to the visor-clip mount.
(Fig. 4 & 5)
Fig. 2
Fig. 3 Fig. 4 Fig. 5
Package Contents & System Diagram
• 3.5˝ LCD Monitor w/Mirror Mode Display
• Color CCD Bullet-Type Camera w/Cable
• Angled Controller Rings (3 sizes)
• Fixing Rings
• A/V Control Module
• Monitor Cable
Camera Installation
1. Locate a suitable camera mounting location on the Car Body
(i.e. rear bumper cover).
2. Drill a 1-1⁄8˝ diameter hole at that location.
3. Attach an Angle Controller Ring to the Camera Body.
4. Insert the Camera Body through the Car Body and attach the
matching Angle Controller Ring to the Camera Body.
5. Secure the Fixing Rings to the threaded portion of the Camera Body.
6. Route the cable to the A/V Control Module location
(i.e. center console).
A/V Control
Module
LCD
Monitor
+12V
Battery
Ground
+12V
Reverse light
CCD
Camera
Fig. 1