VKF Renzel Professional 80.1078.1 User manual

1
4
7
2
5
3
6
Counter M
This counter is packed in 2 bags.
One for the base and tabletop, and one for
the wrap (incl. print).
Attach the print until you’re half way.
The counter is now ready to use, and can
hold up to 50 kg.
To dismantle: open the counter half way
and take off the table top.
Place the base on the floor, with the white
side with plastic feet down.
Then slide in the table top so it leans on
the curve of the wrap, and the hook and
loop tape connects.
Now you can take the print off completely,
and store the parts in the separate bags.
To attach the wrap, start at one side of the
hook and loop tape strip.
Continue to attach the wrap around the
base and table top, until it’s attached all
the way.
Make sure you roll up the wrap with the
print on the outside, for longer durability.
VKF Renzel
829

1
4
7
2
5
3
6
Shelf
Pin Hook
Locate the 4 grooves on the inside of the
wrap, 2 in the front and 2 in the back.
Place the hook between the 2 pins on the
left side, connecting them together.
The shelf is now in position and can hold up
to 10 kg.
Slide the pins in to the grooves. Keep them
vertical, so you don’t damage the print on
the other side.
Slide in the shelf and place it on top of the
hook on the left side.
Open the counter slightly, to create more
working space for the pins in the front.
Now lift the right side of the shelf and
place the hook between the 2 pins on the
right side.
VKF Renzel
829