VPixx Technologies VPX-ACC-5150 User manual

MRI Mirror
Assembly Instructions
(P/N VPX-ACC-5150)
Overview
These assembly instructions will help you assemble your VPixx Technologies front surface mirror.
The front surface mirror is an MR safe product.
WARNINGS AND MARKINGS MUST BE OBSERVED! Before installing and using your front
surface mirror, familiarize yourself with the MR room safety symbols that are found on your
equipment. These are explained in the following table.
Table 1 MR room safety symbols
Symbol
Name
Description
MR safe
Objects and components marked with the green MR safe icon
present no danger for staff and equipment when in the MR
room.
Conditionally
MR safe
The yellow Conditionally MR safe icon indicates objects and
components that are MR safe in a limited fashion. Specified
safety distances limit how close the object or component in
question may be from the magnet.
MR unsafe
The red MR unsafe icon marks objects or components which are
strictly prohibited from entering the MR room.

MRI Mirror
assembly instructions
Copyright © 2020 VPixx Technologies Inc. All Rights Reserved
2
Required Assembly Material
To assemble a front surface mirror, you will need the items included in your shipping package.
Item
Name
Quantity
Required
Front surface mirror
1x
Screen holder
(32’’ aluminium profile)
1x
Support leg
(40 ¾’’ aluminium profile with support brackets)
2x
Foot support
(12’’ aluminium profile with support brackets)
2x
Rubber holder
2x
4 mm Hex MRI safe
1x

MRI Mirror
assembly instructions
Copyright © 2020 VPixx Technologies Inc. All Rights Reserved
3
Assembly Steps
1. Unpacking
Unpack the MRI Mirror components from the shipping boxes and lay the different items on a stable
surface.
2. Assembly of the vertical supports
Insert the first support leg into a foot support, ensuring that the support leg is in its correct upright
position. Use the 4 mm Hex to secure it in place. Repeat for the second support leg and foot support.
These two assemblies now form the two vertical supports.

MRI Mirror
assembly instructions
Copyright © 2020 VPixx Technologies Inc. All Rights Reserved
4
3. Adding the screen holder
Using the 4 mm Hex, add and tighten the screen holder to one of the vertical supports. Repeat for
the second vertical support.
4. Inserting the front surface mirror
Add the front surface mirror to the support assembly. Simply slide it
down into each of the vertical support grooves until it settles into the
screen holder groove.
WARNING! The mirror is very fragile

MRI Mirror
assembly instructions
Copyright © 2020 VPixx Technologies Inc. All Rights Reserved
5
5. Inserting the rubber holder
From top to bottom, slide the rubber holder into each side. The rubber holder should be installed to
the back of the front surface mirror in order to stabilize it in its position.
Finally, install the cover cap on each support leg.