Vremi VRM050719N User manual

Side Table | 1
Every Sofa Needs
A Sidekick
Side Table
This Is A Manual.

Side Table | 3
In the event this product malfunctions, or you believe it is
defective, please contact Customer Service at
Vremi.com/chat, 1 [phone] or suppor[email protected]
and hold onto the defective product (pending further
instruction). A defective product should be clearly marked or
stored where it cannot be used by mistake. Failure to keep the
product in its original quality from the time of receipt may limit
the extent to which Vremi™ may provide recourse.
Important Safety Instructions
1. Identify all parts and hardware to ensure that you have everything you need before throwing
away the packaging.
2. Check and measure the bolts before fastening them to the appropriate parts.
3. Do not tighten hardware until the entire assembly is complete, unless directed otherwise.
4. Keep small parts, hardware, and plastic bags out of children’s reach.
CAUTION: We do not recommend using a drill or a power screwdriver. It may cause the screws to
break or strip.
SAVE THESE INSTRUCTIONS
For Household Use Only

4| Side Table Side Table | 5
List of Hardware
A
Cam Bolt
8 Pcs
L
Drawer Slide (Right)
1 Pc
B
Cam Lock
8 Pcs
M
Drawer Slide (Left)
1 Pc
C
Dowel Ø6 × 30 mm
8 Pcs
N
Foot Pad
4 Pcs
D
Screw Ø3 × 12 mm
12 Pcs
O
Drawer Support and
Screw Ø4 × 16 mm
4 Pcs
E
Screw Ø4 × 35 mm
9 Pcs
P
Wall Anchor
1 Pc
F
Screw Ø4 × 12 mm
20 Pcs
Q
Screw Ø4 × 12 mm
1 Pc
G
Drawer Handle
1 Pc
R
Safety Strap
1 Pc
H
Screw Ø4 × 10 mm
1 Pc
S
Washer
2 Pcs
I
Metal Bracket
4 Pcs
T
Anti-Tip Bracket
1 Pc
J
Side Panel Slide (Left)
1 Pc
U
Phillips Screwdriver
1 Pc
K
Side Panel Slide (Right)
1 Pc
List of Parts
1
Top Panel
1 Pc
7
Drawer Left Panel
1 Pc
2
Left Side Panel
1 Pc
8
Drawer Right Panel
1 Pc
3
Right Side Panel
1 Pc
9
Drawer Back Panel
1 Pc
4
Back Panel
1 Pc
10
Drawer Bottom Panel
1 Pc
5
Bottom Panel
1 Pc
11
Drawer Front Panel
1 Pc
6
Leg
4 Pc

6| Side Table Side Table | 7
10
7
8
9
6
6
6
6
5
3
4
2
1
11
The Breakdown...Before Assembly
CAM LOCK
When fitting the Cam Lock, ensure that the starting position is correct before connecting the Cam Bolt.
The Cam Bolt head should be in the center of the Cam Lock when connecting the two panels.
You must insert the Cam Bolt first, then insert the Cam Lock.
Turn the Cam Lock
clockwise to tighten.
- Remove all packaging materials.
- DO NOT fully tighten the screws and bolts until the assembly is finished.
- Keep all hardware and / or parts out of children’s reach.
CAM BOLT
When tightening the Cam Bolt, ensure that the shoulder is flushed with the panel. Do not overtighten the Cam
Bolt.
Shoulder

8| Side Table Side Table | 9
Installation
STEP 1
1. Connect the Drawer Panels (7), (8) and (9) using Screws (E). Slide the Drawer Bottom Panel (10)
into the grooves in the drawer sides and the back panel.
2. Attach Cam Bolts (A) to the Drawer Front Panel (11).
Installation
STEP 2
1. Attach the Drawer Front Panel (11) to the Drawer Side Panels with the Cam Bolts.
2. Insert Cam Locks (B) into the holes of the Drawer Side Panels. Make sure the arrows on the
CamLocks point toward the Cam Bolts.
3. Rotate the Cam Locks clockwise to ensure they are securely fastened.
4. Attach the Drawer Handle (G) to the Drawer Front Panel with a Screw (H).
5. Flip over the assembled drawer. Attach the Drawer Slides (L) and (M) to the bottom of the Drawer
Side Panels using screws (D). Attach Drawer Support (O) to the back of the Drawer Bottom
Panel(10) using Screws (D).
E
A
U
7
9
8
10
H G
B× 4
× 4
× 4
M
L
D× 6
O× 4
10
10
7
98
11
11

10 | Side Table Side Table | 11
Installation
STEP 3
1. Attach the Side Panel Slides (J) and (K) to the Side Panels (2) and (3) with Screws (D). Make sure
the centers of the screw holes on the slides are in line with the centers of the pre-drilled holes on
the side panels.
2. Attach the Cam Bolts (A) to the Top Panel (1).
Installation
STEP 4
Attach Wall Brackets (T) or Safety Straps (R). This step can also be completed last.
· For Wall Brackets: Use Screws (Q) to fasten the Brackets (T) to the Top Panel (1).
· For Safety Straps: Use Screws (Q) and Washers (S) to fasten the Safety Straps (R) to the Top Panel (1).
Note:
To prevent the risk of tipping and serious injury, the use of wall brackets or safety straps is highly encouraged.
1
2
3
A
D
J
K
× 4
× 6
Q
Q
T
S
R
1
1

12 | Side Table Side Table | 13
Installation
STEP 5
1. Insert Dowels (C) into the Top Panel (1).
2. Attach the Side Panels (2) and (3) to the Top Panel using Dowels (C) and Cam Bolts (A).
3. Insert Cam locks (B) into the holes of the Side Panels and make sure the arrows on the Cam
Locks point toward the Cam Bolts. Rotate the Cam Locks clockwise to fix them in place.
.
Installation
STEP 6
Slide the Back Panel (4) into the groove as shown in the figure below.
B× 4
C× 4
1
2
3
4
Note: The hole in the middle of the back panel
is for wall anchor or safety strap assembly.

14 | Side Table Side Table | 15
Installation
STEP 7
1. Insert Dowels (C) into the Side Panels as shown in the figure below.
2. Attach the Bottom Panel (5) to the body of the side table using Dowels and Screws (E).
Installation
STEP 8
1. Attach Metal Brackets (I) to the Bottom Panel using Screws (F).
2. Screw the Legs (6) to the Metal Brackets (I).
3. Attach the Foot Pads (N) to the bottom of the Legs (6).
C× 4
E× 4
5
I× 4
F× 20
6× 4
N× 4
5

16 | Side Table Side Table | 17
Installation
STEP 9
Slide the drawer to test if it works well.
11
1
Installation
STEP 10
Move the side table to its final position. Fix the Bracket or Safety Strap to the wall and make sure it is firmly
attached. Ensure all screws and bolts are securely tightened.
ø 6 mm
ø 6 mm
E
E
S
T
RP
P

18 | Side Table Side Table | 19
Warranty Information
Vremi™ offers a 12-month limited warranty on all products purchased new and unused from Vremi LLC or an
authorized reseller, with an original proof of purchase and where a defect has arisen, wholly or substantially,
as a result of faulty manufacturing, parts, or workmanship during the one-year warranty period from the date
of purchase. The warranty does not apply where damage is caused by other factors, including but not limited
to: (a)normal wear and tear; (b) abuse, mishandling, accident or failure to follow operating or installation
instructions; (c) exposure to liquid or infiltration of foreign particles; (d) servicing or modification of the product
other than by Vremi™; (e) use other than ordinary residential wear or any use for which the product was not
intended for. This warranty is not transferrable and does not extend to items re-sold, donated, or otherwise
transferred from or by the original purchaser. If you experience any issues with your Vremi™ product, please
contact us at [e-mail].
Manufacturing Information
This manual covers all items with the model number:
VRM050719N
Warning
Keep all plastic bags away from children.
Drop Us A Line
CHAT WITH US CALL US EMAIL US
vremi.com/chat 1 [phone] [email protected]
Installation
Warning!
Serious or fatal injury can occur from the furniture tipping over.
To prevent the furniture from tipping over, we recommend
permanently fixing it to the wall.
Wall anchor and hardware are included with this product. Please
make sure the hardware is suitable for your walls before installing,
as different wall materials may require different anchor types.
Children may die from the furniture tipping
over. To reduce the risk:
• ALWAYS install the tip over restraint provided.
• NEVER put a TV on the side table.
• NEVER allow children to stand, climb, sit, or hang
on the side table.