VS Sassoon Metro Groom User manual

Model VSM837A
METRO GROOM
ALL-IN-ONE GROOMING SYSTEM

IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are
present, basic safety instructions should always be followed,
including the following:
Polythene bags over product or package may be dangerous.
To avoid danger of suffocation, keep this wrapper away from
babies and children. This bag is not a toy.
DANGER: When the unit is used in a bathroom, unplug it after
use since the proximity of water presents a hazard even when the
appliance is switched off.
WARNING: Do not use or leave the AC power adaptor in a
position where it can become wet or there is a danger of
it falling into a basin or other vessels containing water.
• Take care to avoid contact between the moving blades of the
unit and the skin, paying particular attention to the face, neck
and hands.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.

IMPORTANT: Always unplug the appliance when not in use or before
cleaning. Do not leave unattended when plugged in or switched on.
Do not place on any heat sensitive surface.
• Do not use any attachments other than those supplied by Conair
Australia Pty Ltd.
• Use this appliance only for its intended use as described within
this instruction booklet.
• Always unplug the appliance when fully charged.
• This appliance is not intended for commercial use.
• Never drop or insert any object into an opening.
• Do not use the appliance with damaged or broken attachment combs
or with any teeth missing from the blades, as injury may occur.
• Do not place on any surface while it is operating.
• Do not use outdoors or operate where aerosol (spray) products
are being used or where oxygen is being administered.
• Keep the cord away from heated surfaces
• Do not use the appliance if it is damaged. In the event of damage,
discontinue use immediately and contact your dealer for instructions
on returning it for examination or exchange. If the supply cord is
damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified person in order to avoid a hazard.
• Never twist or pull on the trimmer cord.
• After use do not wrap the cord around the appliance as in time
this may cause the cord to fracture. Coil cord loosely by the side
of the appliance in storage.
• Always ensure that the voltage to be used corresponds to the
voltage marked on the unit.
• For additional protection, the installation of a residual current
device (RCD) with a rated operating current not exceeding
30mA is advisable in the electrical current circuit supplying the
bathroom. Ask your installer for advice.

METRO-GROOM
ALL-IN-ONE GROOMING SYSTEM
FEATURES:
1. 32 mm blades: Moveable
blade - W-Tech: CMS
(ChromeMolybdenum-
Stainless Steel) / fixed Blade:
stainless steel
2. 2 cutting guides (2-14 mm
and 3-15 mm) for hair and
beard
3. 6-position precision guide
(from 0,5 to 3 mm) for
stubble and very short cuts
4. Shaving head for body
+ 1 cutting guide (3 mm)
for a quick and even shave
of all the parts of your body
5. 7 mm precision blade, to
create precisely contours and
original designs
6. Nose/ear accessory, to
eliminate unwanted nose
and ear hair
7. On/off switch
8. Power indicator light
9. Cleaning brush
10. Charging and storage base
11. Oil

4
2
2
3
6
1
10
5
7
8
9
114

INSTRUCTIONS FOR USE
• A plastic cover has been placed over the plug to protect it from
damage. Remove the plastic cover before inserting into a suitable
power outlet.
• Always inspect the appliance to ensure the trimmer heads are free
from hair, etc. Check also signs of damage and ensure that the
blades are running smoothly.
• If the blades have been rinsed under water, ensure that the blades
are properly oiled.
• Ensure the appliance is switched off before plugging into a
suitable power outlet.
CHARGING THE TRIMMER
(FOR CORDLESS OPERATION)
NB - ENSURE THE POWER HANDLE IS COMPLETELY DRY BEFORE
RECHARGING.
IMPORTANT: Before using the appliance for the first time, charge
for a full 16 hour continuous charge. Maximum battery capacity
will only be reached after 3 charging and discharging cycles. After 3
cycles, the trimmer must still be charged for 16 hours.
In order to maintain optimum capacity of the rechargeable batteries,
every 3 months the trimmer should be recharged for 16 hours.
The charging cord can be placed into the recharging/storage stand
(as assembled) or removed and placed directly into the base of the
trimmer.
1. Plug the AC power adaptor into a 100v - 240v power supply.

2. When the appliance is switched off, place the appliance onto the
recharging/storage stand or plug the adaptor directly into the
base of the trimmer.
3. Switch the adaptor on and the red LED charging light on the
trimmer will illuminate to indicate that the adaptor is correctly
inserted into the trimmer and connected to the mains power
supply.
4. A 16 hour full charge will provide 40 minutes usage time.
INSERTING THE ADAPTOR CORD INTO THE STAND
1. Remove the trimmer, attachments and accessories from the
stand.
2. Hold the recharging/storage stand upside down.
3. Insert the adaptor plug into the hole on the base of the stand
and push firmly into position.
4. Route the cord through the channel on the base of the stand.
5. Place your thumb on the hinged back cover and push the cover
over the adaptor plug (to the right) to secure the cord and plug
in place.
CORDED USE – OPERATION WITH POWER CORD
1. Remove the AC power adaptor from the recharging/storage
stand. To do this, turn the base over to the underside with the
cord facing you. Using your thumb, push the hinged back cover
to the left until it pivots clear of the inserted plug adaptor. Pull
the plug upwards and remove from the base.

2. Plug the AC power adaptor directly into the base of the trimmer.
3. Plug the AC power adaptor into a 100v – 240v power supply.
Switch the power on, and the trimmer can now be used in cored
operation.
NOTE: If battery power is weak, wait about 2 minutes before
switching the trimmer on.
NB – NEVER USE THE TRIMMER IN CORDED OPERATION IF YOU
INTEND TO USE THE TRIMMER IN THE SHOWER OR UNDER RUNNING
WATER, AS THIS WILL CAUSE INJURY.
ATTACHING AND REMOVING ACCESSORIES
Make sure that the unit is switched off before changing the
trimmer head or accessories.
To attach a head, fit the base of the accessory onto the unit
pressing it until you hear a click.
To remove a head, hold the handle of the unit in one hand and
push up on the head with your free hand to remove it (g.2).
To remove the body comb guide, push up one side of the comb
(g.3).
fig.2 fig.3

WHAT ATTACHMENTS TO USE
Hypoallergenic
Foil Shaver
32mm
Trimmer
Blade
Tramliner
Blade
Rotary
Blade
Bodyzones:
*Chest and
Stomach
*Back and
Shoulders
*Underarms
*Legs
*Groin Area
Beard
Beard Line
Stubble
Moustache
Neckline
Hair
Sideburns
Nose Hair
Ear Hair
Eyebrows

USING THE ATTACHMENTS AND COMB GUIDES
Hypoallergenic Foil Shaver
The hypoallergenic foil shaver has been specially designed for
shaving all bodyzones - chest and stomach area, back and shoulders,
underarms, legs and the groin area. It will leave the skin feeling
clean, smooth and refreshed. The dual independent trimmers on
either side of the foil shaver are designed to shorten long hair and
allow you to easily achieve precise shaving.
The 100% waterproof design makes it ideal for shaving body hair
in the shower, for no mess grooming or as a dry shave. You can
use shaving aids such as foam or gel with this product to achieve a
cleaner, more refreshing shave.
1. Ensure the trimmer is switched off.
2. Attach the hypoallergenic foil shaver attachment.
3. For optimum results, it is recommended to trim the hair rst if it
is quite long (refer to ‘32mm Trimmer Blade and Bodygroomer
Comb Guide’ for further information).
NB – Always inspect the foil whilst shaving for signs of damage.
Never shave with a damaged foil as this may result in injury.
Wet Shaving:
1. Thoroughly wet the body with warm water and apply foam or
gel. This will help to lubricate the body and enable the shaver
to glide across then skin for increased closeness and reduced
irritation.
2. Move the shaver over the skin, applying minimal pressure only as
this allows the hairs to be shaved much more quickly and cleanly.
Do not press.
3. For the closest shave, shave against the direction of hair growth,
or with the hair growth, whichever is preferred, but remember
that hair grows in different directions.