VS Sassoon VSM725A User manual

1
TOOL TIPS
THELITHIUMTRIM
for the lithium powered beard
& stubble trimmer
VSM725A

2
HEY YOU!
TAKE A BOW FINE SIR.
THINGS ARE LOOKING UP
& YOU’VE JUST MADE A
QUALITY PURCHASE
WITH THIS NEW GROOMING TOOL.
WE KNOW YOU’VE GOT THIS, BUT BEFORE YOU JUMP INTO
USING YOUR NEW SIDE KICK, HERE’S A FEW TIPS & TRICKS
TO KNOW BEFORE LETTING YOUR CREATIVITY RUN LOOSE.
HIT UP VSFORMEN.COM.AU FOR MORE GROOMING & INSPIRATION.

THE LITHIUM TRIM / TOOL TIPS
3

THE LITHIUM TRIM / TOOL TIPS
4
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when children are present, basic
safety instructions should always be followed, including the following:
Polythene bags over product or package may be dangerous. To avoid danger of
suffocation, keep this wrapper away from babies and children. This bag is not
a toy.
DANGER: When the unit is used in a bathroom, unplug it after use
since the proximity of water presents a hazard even when the
appliance is switched off
WARNING: Do not use or leave the AC power adaptor in a position where it
can become wet or there is a danger of it falling into a basin or other vessels
containing water. Keep the appliance dry, unless it otherwise specified. Do
not use this appliance in or near bathtubs, showers, basins or other vessels
containing water.
- Do not immerse appliance in water or other liquids.
- Do not reach for an appliance that has fallen into water. Unplug immediately.
- Take care to avoid contact between the moving blades of the unit and the
skin, paying particular attention to the face, neck and hands.
- This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the
appliance.

THE LITHIUM TRIM / TOOL TIPS
5
IMPORTANT: Always unplug the appliance when not in use or before cleaning.
Do not leave unattended when plugged in or switched on. Do not place on any
heat sensitive surface.
- Do not use any attachments other than those supplied by Conair Australia
Pty Ltd.
- Use this appliance only for its intended use as described within this
instruction booklet.
- Always unplug the appliance when fully charged.
- This appliance is not intended for commercial use.
- Never drop or insert any object into an opening.
- Do not use the appliance with damaged or broken attachment combs or with
any teeth missing from the blades, as injury may occur.
- Do not place on any surface while it is operating.
- Keep the cord away from heated surfaces
- Never twist or pull on the power cord.
- Do not use an extension cord with this appliance.
- After use do not wrap the cord around the appliance as in time this may cause
the cord to fracture. Coil cord loosely by the side of the appliance in storage.
- Do not use outdoors or operate where aerosol (spray) products are being
used or where oxygen is being administered.
- Do not use the appliance if it is damaged. In the event of damage, discontinue
use immediately and contact your dealer for instructions on returning it for
examination or exchange. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified person in order
to avoid a hazard.
- Always ensure that the voltage to be used corresponds to the voltage marked
on the unit.
- For additional protection, the installation of a residual current device
(RCD) with a rated operating current not exceeding 30mA is advisable in
the electrical current circuit supplying the bathroom. Ask your installer for
advice.

66
1. Diamond sharpened
stainless steel blades
2. Lithium-ion power
3. Cord/cordless use
4. 30mm trimming blade
5. Foil shaver
6. 3 position comb guide (1mm
to 2mm) for short or shadow
stubble
7. 6 position comb guide (4mm
to 18mm) for keeping your
beard in top shape
8. Cleaning brush
9. Oil
THE LITHIUM TRIM
BRAVO. YOU’VE MADE A QUALITY PURCHASE.
The Lithium Trim is the lithium powered beard & stubble trimmer.
1
2 5
3
4
768 9
THE LITHIUM TRIM / TOOL TIPS

THE LITHIUM TRIM / TOOL TIPS
7
PREPPING YOUR
NEW TOOL
CHARGING
The Lithium Trim is so easy to use. But before you start using your new tool, you
must take the time to charge it overnight for 3 hours before its first use. Your
new tool comes with a small amount of charge, but the initial charge will ensure
your new tool will have optimum power performance to give you smooth fast
cutting, every time.
- Before using for the first time, fully charge your new tool continuously
for 3 hours.
- Maximum battery capacity will only be reached after 3 charging & discharging
cycles.
- To charge the trimmer, first ensure your new tool is switched off, then insert
the small plug on the charging adaptor into the hole on the base of the
trimmer. Plug the charging adaptor into a suitable mains power socket and
switch on.
- The red charging LED indictor light on your new tool will flash when correctly
connected to the mains power. When it is fully charged, the red charging LED
indicator light will turn red and stop flashing.
- A quick charge of 30 minutes provides 20 minutes cordless runtime.
- A full charge will supply 60 minutes cordless runtime.
- To maintain optimum capacity of the rechargeable battery, it is highly
recommended to fully discharge & then recharge your tool for 3 hours every
3 months.
WARNING: if the charging light suddenly starts to flash rapidly, the
appliance is faulty. If this happens, please stop charging and remove the adapter
from the outlet and contact our customer care center for further advice.

THE LITHIUM TRIM / TOOL TIPS
8
HOW TO USE
THE LITHIUM TRIM
BEFORE USING
• Always inspect the trimmer blades for noticeable signs of damage.
• Always inspect the trimmer blades before use to ensure they are free from
hair, debris etc.
• Ensure the trimmer is sufficiently charged before use.
• If the foil is cracked, broken or loose, do not use it again and replace with a
new foil. Using a foil in a faulty condition can cause injury.
• Do not shave on open wounds, cuts, burns, warts, moles or on sunburned
skin.
• Do not use the foil shaver if you suffer from skin irritations or infections,
such as psoriasis or eczema. If at all unsure always consult your doctor
before use.

THE LITHIUM TRIM / TOOL TIPS
9
CHANGING THE ATTACHMENT HEADS
1. Before changing the attachment heads, make sure your trimmer is switched
off.
2. Remove any comb guides attached to your trimmer.
3. To remove an attachment head, hold the handle of the trimmer with one hand,
while holding the attachment head with the other hand. Pull the attachment
head back and away from the front of the handle.
4. To attach an attachment head, the driving pin (Fig. 1) needs to be in a central
position. If it is not in the centre, manually move the pin into position. Then,
making sure that the base of the attachment head is seated in the handle,
click the attachment head into position.
Fig. 1

THE LITHIUM TRIM / TOOL TIPS
10
TRIMMING TIPS
Hit up www.vsformen.com.au for more grooming tips & inspiration.
USING THE 30MM TRIMMING BLADE
The 30mm trimming blade has been designed for stubble, beard & moustache
trimming + shaping.
The following comb guides are for use with the 30mm trimming blade:
• 3 position comb guide (1mm to 2mm) for short or shadow stubble and the;
• 6 position comb guide (4mm to 18mm) for keeping your beard in top shape.
The 30mm trimming blade can also be used without any comb guide attached to
outline, and for an even closer finish.
Using the 30mm trimming blade to outline
The 30mm trimming blade without a comb guide attached will cut roughly to a
length of 0.5 mm.
1. Do not attach a comb guide.
2. Hold the trimmer upside down with the blade facing downwards, yet flat against
the skin.
3. Move the trimmer gently downwards in small strokes around the edge of the
area you wish to outline.
4. Having defined the outline, hold the trimmer with the blades pointing upwards,
yet flat against the skin and move the trimmer upwards against the direction of
hair growth. This will trim the unwanted hair adjacent to the outline.
BE CAREFUL NOT TO APPLY EXCESS PRESSURE
TO THE BLADE, AS THIS MAY DAMAGE THE BLADE
AND CAN RESULT IN INJURY TO THE SKIN DURING
TRIMMING.