VTech Baby Baby Safe Turtle Thermometer User manual

© 2016 VTech
Printed in China
91-003200-004
User’s Manual
UK
Baby Safe Turtle Thermometer

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

Rotate the packaging locks 90 degrees
counter-clockwise.
Pull out the packaging locks.
2
LIGHT-UP
THERMOMETER
BUTTON
SCOOP & POUR
TURTLE CUP
WATER SENSOR
ON/OFF
BUTTON
WATER WHEEL
LIGHT-UP
BUTTON
SPINNING
STAR FISH
INTRODUCTION
Thank you for purchasing the VTech®Baby Safe Turtle Thermometer
learning toy!
Baby Safe Turtle Thermometer is an innovative bath toy for parents
and infants. Parents can press the light-up thermometer button to hear
the temperature of the water announced. Baby can press the light-up
button to be rewarded with fun phrases, sounds and short tunes. They
can also use the scoop and pour turtle to pour water over the water
wheel.
Introduction

33
INCLUDED IN THIS PACKAGE
• One VTech®Baby Safe Turtle Thermometer learning toy!
• One scoop & pour turtle cup
• One user’s manual
WARNING:
All packing materials, such as tape, plastic sheets, wire ties, and
tags are not part of this toy, and should be discarded for your
child’s safety.
NOTE:
Please keep this user’s manual as it contains important
information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a screwdriver
to loosen the screws.
3. Install 1 new AA (AM-3/LR6) battery
following the diagram inside the
battery box. (The use of a new
alkaline battery is recommended for
maximum performance.)
4. Replace the battery cover and
tighten the screw to secure.
5. When closing the battery cover
ensure that the screws are securely
tightened. This will avoid any water
leakage.
Included In This Package/Getting Started
UNLOCK THE PACKAGING LOCKS
Turn the packaging lock counter-clockwise
several times.
Pull out and discard the packaging lock.
1

4
BATTERY NOTICE
• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
With the VTech®Baby Safe Turtle Thermometer safety comes
first. To ensure your child’s safety, please ensure the battery
cover is securely locked into position to avoid injury.
Getting Started

5
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product or
batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com
Keep the speaker above water. If the speaker lls up with water,
remove the turtle from the water and allow the water to drain away
from the speaker.
Getting Started

6
Product Features
PRODUCT FEATURES
1. ON/OFF BUTTON
To turn the unit ON, press the ON/OFF
BUTTON ( ). To turn the unit OFF, press
the ON/OFF BUTTON ( ) a second time.
2. THERMOMETER
The THERMOMETER is waterproof and
can be fully submerged in the water. For
the most accurate reading, mix the water
before adding the thermometer to the
water. Measure the temperature twice
before putting your child in the bath. See
additional information below.
3.WATER SENSOR
The WATER SENSOR is located on the
bottom of the turtle. The turtle can read
the temperature of the water when the
bottom of the turtle is fully submerged in
the water. Leave the turtle in the water for
a consistent temperature reading.
4. LIGHT-UP THERMOMETER BUTTON
1. The LIGHT-UP THERMOMETER
BUTTON is located on the side of
the turtle. Press and hold the button
to read the temperature of the
water. You will hear the temperature
announced and you will hear if the

7
Activities/Product Features
temperature is too hot, too cold or just right. You will also see the
corresponding light indicator light up based on the temperature
reading.
2. The ideal water temperature is
between 36-39ºC. If the temperature
is 39ºC or higher, the turtle will
announce the temperature and that
the water is too hot. The hot icon
will flash as a visual warning. If the
temperature is above 39ºC DO NOT
place your baby in the bath. You will
risk scalding your baby. Add some
cool water to reduce the temperature
of the water. Check the temperature
again before putting your baby in the
bath.
3. If the temperature is 36ºC or
lower, the turtle will announce the
temperature and that the water is
too cold. The cold icon will flash as
a visual warning. Add some warm
water and check the temperature
again before putting your baby in the
bath.
4. For typical bath water temperatures, the accuracy of the
thermometer is normally at +/- 1.5°C range.
5. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech®Baby Safe Turtle Thermometer
will automatically power-down after approximately one minute when out
of the water and eleven minutes when in the water without input. The
unit can be turned on again by pressing any button. The water sensor
will not turn the unit back on.

8
ACTIVITIES
1. Press the on/off button to turn the
unit on. You will hear a fun sound, a
song and a phrase.The light will flash
with the sound.
2. When the turtle is in the water, press
and hold the light-up thermometer
button to hear a playful tune, the
temperature of the water and a
phrase advising if the water is too
hot, too cold or just right. Press the
light-up thermometer button quickly
to hear a song or a melody. When
the turtle is out of the water, press
the light-up thermometer button to
be reminded to put the turtle into the
water.
3. Press the light-up button to hear
a playful phrase and a sound or a
short tune. The light will flash with
the sounds.
4. To attach the little turtle to the big turtle place it onto the groove on
the big turtles tail.
Activities

9
Melody List/Sing-Along Song Lyrics
MELODY LIST:
1. Sailing, Sailing
2. My Bonnie Lies Over the Ocean
3. Sailor’s Hornpipe
4. Ring Around the Rosy
5. A-Tisket, A-Tasket
6. Aloha Oe
7. Down By the Riverside
8. Cockles & Mussels
9. Good Morning Merry Sunshine
10. Shoo Fly Don’t Bother Me
11. Skip To My Lou
12. Roses are Red
SING-ALONG SONG LYRICS
SONG 1
Three sea turtles swimming in the tub,
Bobbing up and down, riding the waves.
SONG 2
Rub-a-dub-dub, three sea turtles in the tub,
Who do you think they be?
The mummy, her babies, a cute family,
Swimming around so free!

10
Care & Maintenance/Troubleshooting
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit is not in use for an extended
period of time.
4. Make sure you empty the water out of all the elements of the unit
and rinse thoroughly before drying so no sediment or cleaning
products are left on the unit.
5. Make sure to dry all the elements of the unit before storing.
6. Do not drop the unit on hard surfaces.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit sit for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with an entire set of new
batteries.
If the problem persists, please call our Consumer Services Department
on 01235 546810 (from UK) or [phone] (outside UK) and a
service representative will be happy to help you.

11
Other Info
IMPORTANT NOTE:
Creating and developing VTech® products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to call our Consumer Services Department on 01235 546810
(from UK) or [phone] (outside UK), with any problems
and/or suggestions that you might have. A service representative
will be happy to help you.

This warranty is valid for the UK and Eire only. For products purchased outside
the UK and Eire, please contact your local distributor or place of purchase.
Join the VTech club online at www.vtech.co.uk
PRODUCT WARRANTY
Thank you for choosing this quality product
from VTech. We hope it will bring many hours
of entertainment, imaginative play and learning.
9. To keep an online record of your warranty, please register your product
online at www.vtech.co.uk/warranty