WAHSON HS-019B-200BK User manual

WAHSON Contents
Assembly Instructions
HS-019B-200BK Drafting Stool
User’s Manual
seat cushion(x1) foot rest
(x1)
seat plate
(x1)
star base
(x1)
caster
(x5)
hand knob(x1) allen wrench(x1)
gas lift(x1)
12
glide(x5)
*alternative part to caster
(x4)
AC D
Press the casters into the holes at the end of
each base leg.
Remove the black cap on the top of gas lift,
then insert the gas lift into the center hole of
the star base.
1 2
Attach the foot rest to the gas lift and tighten
the hand knob to lock it into position. Make
sure the gap of the rubber ring is at opposite
side of the screw hole.
back(x1) connecting tube
(x1)
plastic cover
(x1)
back
connecting plate
(x1)
(x2)
B

WARNING!
The black cap on top
of the gas lift must
be removed before
inserted into the
seat.
Attach the seat to the base.
To secure seat into base, sit down on the stool.
Assemble the back.
3
56
3 4
Attach the back to the plate.
A
Easy adjustment instructions
Seat height adjustment
Foot rest height
adjustment
Sitting in the seat, pull up on the
lever on the right side of the
seat.
Lower or raise the seat to your
desired height, then release the
lever to lock the seat height into
position.
Loosen the hand knob on foot
rest, then, adjust to desired
height.
Tighten the hand knob to lock
the foot rest height into position.
CAUTION: TO AVIOD PINCHED
HAND, DO NOT PUT THE FOOT
REST HIGHER THAN THE LINE
MARKED AT GAS LIFT.
Back rest distance
adjustment
Loosen the hand knob
underneath the back rest plate,
then, adjust the back rest to
desired position.
Tighten the hand knob to lock
the back rest into position.
Safety and Compliance
• Use care when handling.
• Please read the instructions completely before assembly.
• Remove all parts from the carton and ensure all parts are included prior to assembly.
• Assemble the chair on the carton or carpet to prevent scratching the chair.
• Be careful not to cross-thread screws.
• Do not use power tools
Attach the seat plate to the seat
cushion.
C
A
C
(X4)
(X1)
A set of glides included in the box
as alternative parts, use them to
disable the rolling function.
To remove inserted
casters/glides, pull out directly.
Contact US:
• [e-mail]
• wahsonchair.com
4
B(X2)
B