WAHSON WS-6080 User manual

WAHSON Contents
Assembly Instructions
WS-6080 Office Chair
User’s Manual
back(x1) seat cushion(x1) headrest set (x1)
arms(x1 L, x1 R)
seat plate(x1)
star base(x1) caster(x5)
gas lift(x1)
6*25mm(x2)
6*25mm(x6)
allen wrench(x1)
8*25mm(x3)
12
A6*20mm(x4)
B C D
A
A(X6)
E
base cover(x1)
A
21
Press the casters into the holes at the end of
each base leg.
Insert the gas lift into the center hole of the
star base.
Attach the arms to the seat cushion.

3 4
56
B C
B
(x2)
D
D
C
Easy adjustment instructions
Seat height adjustment
Back tilt and lock
Sitting in the seat, pull up on the lever
on the right side of the seat.
Lower or raise the seat to your
desired height, then release the lever
to lock the seat height into position.
Sitting in the seat, pull up the lever on
the left side of the seat and lean back
against the backrest to adjust the
back to your desired angle, then,
push in the lever to lock the back into
position.
Leave the lever at upper position to
release the lock of the back and
enable the rock function.
Tilt tension adjustment
Armrest adjustmentHead rest adjustment Lumbar support adjustment
*Note: This function is only available with
backrest unlocked.
Turn the tilt knob clockwise to make it
easier to rock your chair backwards.
Turn the knob counter-clockwise to
make it harder to rock your chair
backwards.
Safety and Compliance
• Use care when handling.
• Please read the instructions completely before assembly.
• Remove all parts from the carton and ensure all parts are included prior to assembly.
• Assemble the chair on the carton or carpet to prevent scratching the chair.
• Be careful not to cross-thread screws.
• Do not use power tools
43
FRONT
FRONT
FRONT
Attach the seat plate to the seat
cushion.
Insert the backrest.
Attach the headrest to the backrest.Attach the chair to the base.
To secure seat into base, sit down on
chair.
(X4) (X3)