Walker Edison W52C4D0 User manual

ITEM # : W52C4D0
Assembly Instructions
  
 
Revised 08/2017
P.1

General Assembly Guidelines
I. Insure that all parts and hardware are available before beginning assembly.
II. Follow each step carefully to insure the proper assembly of this product.
III. Two people are recommended for ease in the assembly of this product.
IV. The four main types of hardware used to assemble this product are wood dowels,
cam bolts and locks, bolts and screws.
V. The provided glue is to secure wood dowels in place. When first inserting dowels,
locate the appropriate hole for the dowel, place a small amount of glue in the hole
and insert the dowel. Wipe away excess glue immediately.
In future assembly steps when dowels are necessary to attach assembly parts
together, place a small amount of glue on the end of the dowel before attaching
parts together. Wipe away excess glue immediately.
VI. A Phillips head screwdriver is required for the assembly of this product.
VII. Power tools should not be used to assemble this product.
P.2
Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.

Parts List
Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.

Insert small dowels (B) into panels (7,8) and slat (3). Insert large dowels (A) into slat (3).
Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.

Insert large dowels (A) into slat (6). Insert small dowels (B) into bottom panel (4). Screw cam bolt (D) into
slat (6).
Attach slat (6) to bottom panel (4) using cam bolts and dowels as guides. Insert cam locks (E) into bottom
panel (4) and tighten with a screwdriver.Screw leg (5) into bottom panel (4).
Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.

Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.

Attach slat (3) to panels (7,8) using dowels as guides.
6
4
Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.

Attach side panel (2) to the opposite side of the assembly from Step 7 using cam bolts and dowels as
guides. Insert cam locks (E) into bottom panel (4) and slats (3,6).
E
E
Tighten cam locks (E) with a screwdriver.
4
Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.

Insert cam locks (E) into the assembly from Step 9 as shown above. Attach top panel (9) to the assembly
using cam bolts and dowels as guides. Tighten cam locks (E) with a screwdriver.
Copyright © 2009, by Walker Edison Furniture Co., LLC. All rights reserved.