Wasserstein Premium Smart Water, Temperature, and Humidity... User manual

Premium Smart Water, Temperature,
and Humidity Sensor
USER MANUAL

In the Box
Parts
Page 1
1 x water sensor 1 x probe cable 1 x holder 1 x micro USB cable
2 x AA batteries 2 x screws 2 x wall anchors
holder
probe
USB cable
cable ports
water sensor
alarm indicator

Setup
Page 2
1. Mount the holder to the wall. Place one screw through the front and mount it
accordingly.
2. Click the water sensor onto the holder.

Page 3
3. Plug the probe cable into the cable port located on the water sensor.
4. Plug the USB cable into the USB port.

Page 4
5. Test the water sensor by placing the proble in a small puddle of water. If the water
sensor has been installed correctly, it will beep when it touches water.
Note: to use AA batteries instead of USB cable, twist the back of the water sensor
counterclockwise until it pops off. Then, insert two AA batteries.