Waterite Apix CLSE-2200-HCSR User manual

POINT OF USE
WATER COOLER
(WITH OPTIONAL FILTRATION SYSTEM)
VERY IMPORTANT!
PLEASE READ CAREFULLY BEFORE USE
Winnipeg, MB Canada
ww.waterite.com
MODEL CLSE-2200-HCSR
OPERATION INSTRUCTIONS

1. OUTER COMPONENTS
1. Upper front panel
2. Heating lamp (red)
3. Cooling lamp (green)
4. Cold tap (blue)
5. Hot tap (red)
6. Drip tray
7. Lower front panel
8. Adjustable feet
9. Top cover
10. Thermostat
11. Fuse
12. Hot water switch
13. Drain cap
14. Inlet
15. Drain plug
16. Power cord
17. Ground wire
18. Condenser
2. INNER COMPONENTS
1. Air lter
2. Float valve
3. Cold water reservoir
4. Float sensor
5. Hot water tank
6. Compressor

1. Supplies hot and cold water for instant food and drink preparation.
2. Fast and highly e󰀩cient cooling due to powerful compressor refrigeration.
3. Food grade stainless steel tanks.
4. Stylish and modern design.
1. Place the unit on a at surface.
2. Maintain a distance of at least 15 cm (6 in) from surrounding furniture and walls.
3. Keep all ventilation openings clear of obstructions.
4. Adjust feet to level unit.
5. Ensure that the main water valve is CLOSED, before connecting to water line.
6. Connect water line to water inlet.
7. Turn on water SLOWLY and check for leaks.
3. PRODUCT FEATURES
5. LOCATING YOUR COOLER
1. This cooler is designed to dispense water only.
2. To be used indoors only, keep away from freezing temperatures.
3. The cooler should not be located in direct heat or sunlight.
4. This product should be used with GFCI outlet to prevent any possible electric shock or re.
5. Clean outer surfaces with a soft cloth only. Do not use chemical cleaners.
6. Your cooler requires periodic sanitizing of internal components to inhibit bacterial growth. We
strongly recommend sanitizing with the WATERITE Biomax Cooler Cleaning Kit (part N. ACCS-
0CK0-0001) every three months.
7. Do not allow children to play with the RED (hot) tap.
8. Do not move abruptly. Do not incline more than 45º. If this cooler has been delivered laying down or
has been laid down at any time it must be set in the upright position for 24 hours before operating.
9. If the power cord is damaged, it must be replaced by a qualied technician in order to avoid any
electrical shock hazard.
10.This unit is not intended to be used by children or persons with reduced physical, sensory, or
mental capabilities, unless they have been given supervision or instructions concerning the use
of the unit.
11. Children should be supervised at all times around the unit.
12.Always check the local plumbing codes before connecting to the water line.
4. IMPORTANT

1. With the power still OFF, turn on the RED (hot) tap until water ows out of it (your unit is equipped
with a child-safe hot tap to avoid accidental activation). DO NOT TURN COOLER ON UNTIL THIS
STEP IS COMPLETE.
2. This cooler is shipped with the HOT water switch in the OFF position. Plug the unit into a three-
pronged grounded outlet only, turn on the HOT water switch (12). The heating and cooling lamps
will light on the front panel.
3. If the unit will not be used for an extended period of time, turn o󰀨 the water main line; unplug the
cooler and empty all water by opening taps (HOT water will be HOT) and the drain plug.
4. If the unit is disconnected from power temporarily, it will take 5 minutes for the unit to restart
completely.
Coolers with ltration systems:
• Carbon cartridges may release carbon dust momentarily at initial start-up, but this is harmless and
will clear immediately.
• The rst amount of ltered water needs to be discarded, as it may contain debris form inside the
storage tanks and lters. Turn o󰀨 the hot water switch and shut o󰀨 the main water line. Empty the
unit by using the faucets and the drain valve.
• Open the water line and let the unit rell completely. Follow steps 1 and 2.
7. OPERATION
The Apix cooler uses
1/4” quick-connect
tubing and ttings.
6. QUICK-CONNECT FITTINGS
1. Close the cold water supply valve. Open the faucet
until the ow of water stops, and then close.
To access the lter compartment:
Remove the drip tray.
Push down and pull out the top of the bottom panel to remove it.
2. Grasp the cartridge to be removed, swing it outwards and twist ¼ turn to the LEFT (COUNTER-
CLOCKWISE). The cartridge will disengage and can be easily removed by pulling it out of the
socket. Repeat for each cartridge to be changed.
8. FILTER REPLACEMENT

3. Wash hands thoroughly. Remove the replacement cartridge from its
box and its sani-sealed protective sleeve. Remove the protective cap.
Make sure the correct cartridge is installed in its socket according to
its colour. Locate the alignment tab on the top of the cartridge (there
are two at 180 degrees from each other) and align with the center front
of the cartridge socket. Push the cartridge straight up into the socket,
while turning ¼ turn to the RIGHT. The cartridge will engage and lock
into place.
Trouble Causes Solution
No water from the taps Air entrance is blocked, or
connection is not turned on Check connection to water line
No hot or cold water
1. Too much water used in a
short time
2. Electrical connection is
loose
1. Wait for unit to re-heat and
cool
2. Make sure the switch is ON
and the unit is plugged in
Loud noise or vibration
1. Incorrect placement
2. Foreign objects lodged in
the cooler
1. Refer to page 2 for correct
placement
2. Remove any foreign object
Water tastes di󰀨erent
1. Water storage tank is not
clean
2. Stored water has been
sitting too long
3. Filters need replacement
1. Clean storage tank
2. Drain water and rell
3. Replace lters
Ine󰀩cient water production
1. Main water valve is not
completely open
2. Plugged lters
1. Open main water valve
2. Replace lters
10. TROUBLESHOOTING
CAUTION: In order to avoid electrical damage, this unit must not be powered by an external device, interrupted by a timer, or
connected to a circuit that is regularly switched on and o.
CORRECT DISPOSAL OF THE UNIT: this product should not be disposed of with household waste. To prevent possible harm
to the environment, dispose of it according to local disposal and recycling programs.
9. WARRANTY
1. This unit is warrantied for failure by defects in material or workmanship for a period of 1 (one) year
from the date of purchase.
2. Any repairs under warranty must be performed by an authorized service center. When making a
claim under the warranty, the original proof of purchase must be supplied.
3. The warranty will be voided when one of the following occurs:
- Wear from normal use;
- Incorrect use, or unit has been abused or tampered with;
- Use of force or breakage from impact or heat.
4. Turn the cold water supply valve ON. Open the faucet and allow the system to run for two minutes
to ush. You may now resume normal use of the system.

Description Part Number Replace every
Carbon Block Filter V360112CC05 3-6 months
5 Micron Sediment Filter V360112PP05 3-6 months
Replacement Filter Kit (1 Carbon Block - 1Sediment) V3602CRK 3-6 months
RO Membrane V360312RO00 1-3 years
UF Filter Cartridge V360312UF00 6-12 months
UF Filter Replacement Kit (1 Carbon Block - 1 Sediment - 1 UF) V360UFCRK 6-12 months
11. REPLACEMENT PARTS