Waterpik Technologies WaterFlosser WP-120 User manual

Fill
Replace
Insert
NO
Gap
Low
PAUSE
High
This device is compatible with global voltages of 100–240VAC, 50/60Hz.
Remove the reservoir from
base and fill with lukewarm
water.
Replace the reservoir onto
the base, PRESSING DOWN
FIRMLY to ensure full seating.
Prior to Very First Use of Unit, Prime Unit:
Set pressure control dial on base to high, point
the handle and tip into sink. Turn unit ON until
water flows from the handle, turn unit OFF.
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap
between handle and
colored tip ring.
1Prepare the Reservoir: Select and Insert Tip: 2
3 4
continued on back
Prime Unit (First Time Use Only): Adjust Pressure and Pause Control:
You can temporarily stop
water flow by pressing
the pause button on
the handle.
For first time
users, adjust
pressure control
to lowest position.
Gradually increase
pressure as you prefer.
Model WP-120
QUICK START GUIDE

ON
Remove
Tip
Eject
Button
For product questions and spare parts, please contact
Waterpik International, Inc. customer services on: [phone]
www.waterpik.co.uk
©2013 Water Pik, Inc.
5Using your Waterpik® Water Flosser:
20017745-F AA
Lean over sink and close lips
enough to prevent splashing, while
still allowing water to flow from
mouth into the sink. Turn unit ON.
Always place tip in mouth
before turning unit on.
Push the tip eject button on the
handle. The control knob will rise,
releasing the tip. Remove the tip.
Caution: Do not press tip eject
button while unit is running.
Aim the tip just above the gumline
at a 90 degree angle.
Starting with the back teeth, follow the
gumline and pause briefly between teeth.
Continue until all areas around and
between teeth have been cleaned.
7REGISTER YOUR
PRODUCT
ONLINE NOW!
6Tip Removal:
Receive up to
£45
in savings on the
purchase of additional
Waterpik
®
products.
www.waterpik.co.uk/registration