WECHEER WE 248 Series User manual
Thank you for purchasing WECHEER professional power tool.
WE 248 is a light, precise, highly flexi le and user-friendly product designed for carving,
engraving, routing, grinding, sharpening, sanding, polishing, drilling and similar tasks.
Please feel free to contact your local suppliers for our other fine tools and accessories.
SPECIFICATIONS
INPUT AC 100V 50/60Hz or 240V 50Hz
OUTPUT DC 24.0V ±5%, LOAD 750mA
RPM Variable Speed: 3,000 ~ 28,000 RPM
COLLET 2.4 and 3.2 collets and collet nut
DIMENSIONS 150mm Length ×24mm Diameter
OPTION Spring Chuck 0~3.2mm
OPERATION
To load a it:
1. Turn off and unplug the device.
2. Press the shaft lock utton.
[Collet]
Press and hold the shaft lock utton.
Use the collet wrench to loosen the collet nut.
Insert the it. (not included)
Tighten the collet securely.
! avoid excessive tightening of the nut.
Usage:
1. Grasp the device like a pen.
2. There is a switch indicator with an orange line on it. Slide the switch to find the speed
needed
from 3,000 to 28,000 RPM. For a complete stop, e sure to slide the switch to the lack dot.
3. Gently touch the piece eing worked on, letting the tool to do the work. Keep hands and
fingers away from the rotating it. The tool operates at speeds up to 28,000 revolutions per
minute, only holding and guiding are required. Do not apply excessive pressure to the device.
4. Slower speeds are recommended for polishing operation. Higher speeds are etter for
carving, drilling, cutting, routing and shaping. Hardwoods, metals and glass usually require
Micro Engraver
WE 248 SERIES
high-speed operation.
SAFETY CONCERNS
Please make sure that the voltage of your wall outlet matches the required voltage.
Always unplug the tool efore swapping or loading accessories, collets, or its.
Do not engage the shaft lock utton while the tool is in use.
The it and collect are in a high temperature that is too hot to e touched y are hands.
Do not use damaged its, which can cause danger.
Keep dust out of eyes and lungs y using a protective eyewear or a dust mask.
Always unplug after use.
Warning:
When the motor is overloaded, the device’s protective mechanism will stop the motor
automatically. Please stop using it immediately until the device returns to work again to
avoid damaging the motor. (damages caused y overloading void your warranty)
MAINTENANCE INSTRUCTION
Frequently clean the ody with soft cloth or air compressor to avoid the dust from preventing
the tool from running smoothly. Never use cleaning solvents or detergents. No replacement
parts are availa le for this tool.
For more information and/or technical support, please visit our we site at:
http://www.wecheer.com or contact us at:
Table of contents
