Wechillit FKG370 User manual

Manual, Operating Instructions
Brought to you by
Wechillit.com Ltd
Wechillit.com Ltd
18 Pride Hill
Shrewsbury
SY1 1DQ
Tel: [phone]
Fax: [phone]

Please read these instructions carefully before putting the appliance
into service. They are brief and contain only information which will
help you to obtain the best performance from the appliance
Take care of all accessories supplied with the appliance.
BOTTLE COOLER / WINE COOLER
INSTRUCTIONS FOR USE
MODEL:
FKG 370
VKG 570

2
CONTENTS
1. Before starting the appliance.
2. How to use the appliance.
3. Maintenance.
4. Has the appliance stopped working?
5. Safety.
6. Technical data.
7. Installation.
8. Change of hinge side.
9. Lighting fixture.
1. BEFORE STARTING
THE APPLIANCE
Check that the cabinet is undamaged.
Please report any damage immediately to
your dealer. Wash the cabinet and inner
lining with a mild unscented detergent and
wipe it dry. Do not use abrasive scouring
powder, steel wool or similar. Connection to
the electricity supply: See head 7 and 8.
2. HOW TO USE THE APPLIANCE
Operating panel. See fig. 5, page 4.
1. Thermostat knob.
2. Indicator for the connection to the
electricity supply (green).
3. Switch for light.
The thermostat knob is adjustable from 0
(stop) to 7 (coldest). Find the position of
the thermostat which gives you the desired
temperature. Start at position 4.
Defrosting
The evaporator is automatically defrosted.
The defrost water is led to a tray on top of the
compressor where it evaporates.
3. MAINTENANCE
Only use an unscented detergent when clea-
ning the cabinet inside.
You may remove the top panel and wash it
when cleaning the cabinet inside.
Switch off the appliance and pull out the plug
when cleaning the cabinet.
The skirting board can be removed to faciliate
a vaccuum-cleaning of the floor. See fig. 1,
page 5.
To make the cooling system work at its
optimum it is necessary from time to time to
clean the wire condensator and the
compressor at the back of the cabinet by
means of a brush or a vaccuum cleaner.
Remember to clean the drain.
4. HAS THE APPLIANCE STOPPED
WORKING?
Before calling a repairman, check that
●The plug is properly plugged into the wall
socket.
●The fuse is intact.
●The power has not been cut off.
●All controls are correctly set.
●Switch off the cabinet for 15 minutes (for
instance at the thermostat). Switch it on
again and after 5 minutes check whether
frost has formed on the evaporator.
●Do not open the cabinet when
unnecessary.
5. SAFETY
Do not store explosive substances in the
refrigerator section, such as gas, cigarette
lighters, petrol, ether or similar. Scrapped
cabinets may become dangerous to
children at play. Therefore, remove the
doors or place the scrapped cabinet in
such a way that children cannot enter it.
Never store liquids with carbon dioxide in the
freezing section.
6. TECHNICAL DATA
This appliance meets the provisions of the
following directives: 89/336/EEC
(electromagnetic compatibility), 73/23/EEC
(electrical equipment designed for use
within certain voltage limits) as amended.
The rating plate, which is placed inside the
appliance (see fig. (6) page (4), provides
various technical information as well as type
and serial number.

3
7. INSTALLATION
See drawings page 5.
Install the cabinet in a dry place and so
that it is not exposed to direct sunlight or
any other source of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base. The
cabinet may not rest against a wall on its
hinged side. When placing the cabinet on a
carpet or on a wooden floor you should
adjust it once more after some time as the
cabinet might settle in soft foundations.
If you want to build the appliance into a cup-
board you must consider 3 factors:
1. There must be space above the
appliance in order to make the cooling
system work satisfactorily. - Fig. 2a,
page 6.
2. When the door is opened the appliance
takes up more room in the width and
therefore the door must either be placed
outside the cupboard or there must be
a space of at least 1,5 cm at the hinge
side. - Fig. 2b and 2c, page 6.
3. The distance to the wall at the hinge
side must be of a sufficient size. - Fig.
2d, page 6.
Furthermore is it possible to build together
two appliance. - Fig. 3, page 6.
If the wine cooler is to be placed next to
another unit, a 25 mm gap must be left.
It is safest to place the earthed wall socket
above the appliance and at least 2.0 m
above the floor. Any local installation rules
for appliances of this kind must be
observed.
During a storm the electricity supply might
be cut off.
You should be aware of this when installing
the appliance in weekend cottages or
elsewhere where you would not
immediately observe that the power has
been cut off. Construction and details in
the accessories are subject to alteration
without previous notice.
8. CHANGE OF HINGE SIDE
Follow the instructions below if you wish to
install the door hinges at the opposite side.
See the drawings on page 7.
Dismantle the top panel cover - fig 1 and 2.
Dismantle the top hinge. To be used later as
bottom hinge at the opposite side - fig 3.
Dismantle the door and its bushing.
Dismantle the bottom hinge - fig. 6.
Place the tension disk and the counter nut
for the hinge pivot on the new bottom hinge.
Mount the door anew.
Tighten the counter nut at the bottom.
Tighten up all nuts.
Mount anew top panel cover and skirting
board cover
9. LIGHTING FIXTURE
See the drawing on page 7.
1. Pull the screen to the left.
2. Pull down the right side of the screen
and take it out.
- Remove the strip - possibly with text - by
pulling it out of the tracks along the whole
length of the profile.
- The fluorescent tube can be replaced.
The mounting is performed in reverse order.
The glow switch can be replaced without
removing the screen.

4
Fig. 6
Fig. 5

5
➭
➭
➭➭
Fig. 1
➭

6
600
600600
min 2000
min 2000min 2000
1850
18501850
150
150150
Fig. 2A
Fig. 2D Fig. 3
min. 25 mm
Fig. 2B
Fig. 2C
max. 548
600
615
min. 15
600

7
CHANGE OF HINGE SIDE
7
12
3
6
4
5

95.20.323.05