Wedge Clamp Systems Inc. EZE ROLLER User manual

EZE ROLLER
10 TON PULLING MACHINE
Assembly Instructions & Replacement Parts List
Assembly Instructions ………………………………….………..………………………………………. 1
Important Safety Information ………………………………………………………………………... 7
Parts Diagram ………………………………………………………………………………………………… 9
WARNING:
All safety precaution statements on the air/hydraulic pump operation instruction supplied must be carefully observed to
help prevent personal injury.
Wedge Clamp Systems Inc. 170-21320 Gordon Way, Richmond, BC V6W 1J8
Tel: [phone] | Fax: [phone] | Toll Free: 1-800-615-9949

1
EZE ROLLER ASSEMBLY INSTRUCTIONS
•Place left the right channel on the floor as shown
•Place Eze Roller base and ram carriage onto the channels in the positions as shown.

2
EZE ROLLER ASSEMBLY INSTRUCTIONS
3.
•Insert the channel mounting bolt through the large hole in the
bottom of the channels and through the Eze Roller base. Place
the nut on the end of the channel mounting bolt, but do not
tighten the nut yet.
•Loosely insert the two channel wedges under the channel
between the base of the channels and the Eze Roller base as
shown,
4.
•Take the loose end of the black nylon strap which is attached to the ram carriage and thread
the strap through the roller cap rollers.
•Install the roller cap and tighten the four roller cap bolts as shown.

3
EZE ROLLER ASSEMBLY INSTRUCTIONS
5.
•Side the ram carriage towards the Eze Roller base a shown
6.
•Stand the Eze Roller into the vertical position as shown.
•Hammer in the two channel wedges at the base of the channel
•Tighten the channel bold and nut

4
EZE ROLLER ASSEMBLY INSTRUCTIONS
•Fit the ringed bearing and the bearing
into the hole in the crank mount bracket from
the inside of the bracket. As seen in the picture
the bearing faces should be flush to the outside
face of the bracket.
•Insert the crank handle into the crank
mount bracket as shown.
•Place the two crank handle washers on
the slotted crank shaft on either side of the
black strap.
•Be sure to mount the washers so that
the bevel flanges on the washers angle AWAY
from the strap.
•Install the split pin into the crank shaft pin hole.
•The pin goes between the outer crank handle washer and the ringed
bearing as shown.
PIN
BEARING
BEARING
CRANK
HANDLE
WASHERS
PIN HOLES
CRANK HANDLE
RIGHT
CHANNEL
CRANK
MOUNT
RINGED
BEARING
STRAP
7.
8.

5
EZE ROLLER ASSEMBLY INSTRUCTIONS
Pulley Pin
Set the ram carriage pulling
height as shown by inserting the
Pulley Pin under the ram
carriage and through the holes in
the channels
Always hold the crank handle firmly
before removing the Pulley Pin
otherwise handle will spin violently
which could cause personal injury.

6
EZE ROLLER ASSEMBLY INSTRUCTIONS

7
IMPORTANT SAFETY INFORMATION
The hydraulic reservoir in the pump must be vented prior to use. Please refer to re-priming
the pump instructions located in Pump User Manual.

8
IMPORTANT SAFETY INFORMATION

9
34

10
21009 8
21009
20055
1, 2, 3,14 Pump Assembly with Hose includes:
(1) 20111; (1)20113; (1) 20053;
(1)20054
1
13007 Bearing
1
13063
Pulley Pin
34.
2