Well DOORBELL-ENDLESS-WL User manual

USER MANUAL
(Kinetic Wireless doorbell)
Thank you for choosing WELL. Please read carefully the following instructions and keep them within
reach.
Reorder No: DOORBELL-ENDLESS-WL

Product Features
1. Long remote distance, open area transmission distance is 100 m~150m.
2. IP44 waterproof transmitter.
3. No interference to or from other wireless doorbells.
4. Low power consumption, long service life.
5. Easy installation, easy to use.
6. Battery-free design, more environmentally friendly.
Product Contains:
Receiver, transmitter, double-sided adhesive sticker screw.
Product Parameters:
Receiver
Transmitter
Power Supply
AC 110-260V 50Hz/60Hz
Pressure 3-4N
Power consumption
stand by 0mA
Transmitter life ＞200,000times
Power consumption
working ＜140mA
-
Working temperature
-20-55°C
-20-65°C
Working frequency
433.92Mhz±0.5Mhz
Waterproof
-
IP44 standard
Volume
4 volume (mute included)
-
Selectable ring tone
51 chord or 45 music
Operating range
100 m to 150m in open area
Product Structure:
Self-Generating Power Button + Receiver

Notice before installation:
1. Non-professionals should not open or maintain it yourself to avoid damaging the sophisticated
electronic components.
2. Please try to avoid installation the device under rain, over expose to sun or close to metal.
3. The actual remote control distance depends on the working environment as they are affected by
interference.
Transmitter Installation:
Double-sided adhesive sticker
Receiver Installation:
1. Insert the receiver into the socket in the specified position.
2. Press the music choice button to select your favorite ringtone, there are 51 chord or 32 music for
your choices.
3. Press the volume control button to adjust volume, there are 4 volume or 3 volume for your choices.
Solving potential problems:
1. Receiver suddenly can't get signal from transmitter
Reason 1: Plug of receiver is loose
Solution1: Re-plug your receiver.
Reason 2: Transmitter is not paired with receiver.
Solution 2: Pairing receiver with transmitter as below.

Pairing procedure:
1. Put the Self-Generating Power Button next to the Receiver, and long press the VOLUME button at the
Receiver for 5 seconds.
2. At the same time, continuous press the Self-Generating Power Button for 5 times.
3. A very loud tone can be heard as confirmation on the DOORBELL. The pairing should have done.
2. Short operating range
Reason: There are too many obstacles like walls, metal doors between receiver and button
Solution: Test operating range before installation and change location.
NOTE: When you turned off the DOORBELL and turning back on again will reset the volume level and
music tone selected previously to default volume level and music tone, but the pairing of between the
BUTTON and DOORBELL will not affected.
Waste electrical and electronic equipment are a special waste category,
collection, storage, transport, treatment and recycling are important
because they can avoid environmental pollution and are harmful to health.
Submitting waste electrical and electronic equipment to special collection
centers makes the waste to be recycled properly and protecting the
environment. Do not forget! Each electric appliance that arrives at the
landfill, the field, pollutes the environment!
Importer & distributor:
SC VITACOM ELECTRONICS
SRL CIF: RO 214527
Tel. [phone]*
[email protected]o, www.vitacom.ro