Well WTST-OUTD-SIGNAL-WL User manual

INSTRUCTION MANUAL
WEATHER STATION WITH
EXTERNAL SENSOR
Thank you for choosing WELL. Please read carefully the following instructions and keep them
within reach.
Reorder No: WTST-OUTD-SIGNAL-WL

FEATURES
1. Buttons description: 4 buttons: SET/ UP/ DOWN/ MEM
2. Weather forecast: Sunny, Partly cloudy, Cloudy, Rainy, Snowy
3. Freezing point indicator
4. Indoor temperature range: -10℃ ~ +50℃
LL.L℃/℉ or HH.H℃/℉will display when out of range
5. Outdoor temperature range: -30℃~+60℃
LL.L℃/℉or HH.H℃/℉will display when out of range
6. Indoor & outdoor humidity range: 1%-99%
LL or HH will display when out of range
7. Traces historical maximum & minimum temp. & humidity values in 24hours
Displays real time environment temperature in ℃ or ℉
9. 12 or 24-hour time display format settable
10. Outdoor unit low battery indicator
11. Temperature and humidity trend
INSTALLATION
Open the battery compartment cover. Insert 2 x AAA batteries to the main unit, and insert 2 x AA batteries to the
transmitter according to the correct polarity showed in the compartment.
After powering on, the weather station will take about 3 minutes to connect with the outdoor transmitter.
RF (OUTDOOR TEMPERATURE AND HUMIDITY)
The main unit will automatically measure the Indoor temperature and humidity after powering on . And then it will
automatically receive RF signal sending back from the external transmitter. The RF receiving status will last for max
3 minutes and the receiving signal will flash. If no signal received in 3 minutes, will exist and stop receiving
outdoor signal. If no signal is matched within 1 hour, no outdoor data “--.--“ will be displayed on the screen.
Press and hold UP button for more than 3 seconds, then manually enter RF re-registration.
REMARKS:
1. The distance of main unit or transmitter should be at least (1.5~2 meters) away from any interfering sources such
as computer monitors or TV sets.
2. Please do not use other electronic products such as headphones or speakers operating at the same signal
frequency (433 MHz), which may cause interference.
3. Neighbors using electronic devices operating on the same signal frequency (433 MHz) can also cause
interference.
TEMPERATURE AND HUMIDITY
1. Indoor temperature range: -10℃ ~ +50℃
2. Outdoor temperature range: -30℃ ~ +60℃
Remarks: LL.L℃ or HH.H℃ will display when out of the above range
3. Indoor and outdoor humidity range: 1%-99%
LL% or HH% will display when out of range
4. Press MEM to check maximum and minimum data; Hold in MEM button to manually clear the record.
(Remarks: Historical record will be cleared automatically at 00:00 every day).
5. Press DOWN button to switch temperature units: ℃ or ℉.
TEMPERATURE TREND
The temperature trend arrow points in different directions depending on whether the latest temperature reading is
higher or lower than previous readings.
Arrow angled upwards=Temperature has risen 1℃ in the past 1 hour.
No arrow=No temperature change in the past 1 hour.
Arrow angled downwards=Temperature has fallen 1℃ in the past 1 hour.

HUMIDITY TREND
The humidity trend arrow points in different directions depending on whether the latest humidity reading is higher or
lower than previous readings.
Arrow angled upwards = Humidity has risen 5% in the past 1 hour.
No arrow = No humidity change in the past 1 hour.
Arrow angled downwards = Humidity has fallen 5% in the past 1 hour.
WEATHER FORECAST
Weather forecast will appear in one of following combinations:
Freezing Point Indicator: Appears when external temperature is between 0-2.9℃.
The freezing point indicator “ ” will flash until the temperature Is out of the range.
When the RF temperature is below 0℃, freezing point indicator “ ” will display on the screen always.
TIME SETTING
In the time mode, press and hold SET button for 2 seconds to begin setting the time.
The digits to be set will be flashing.
Press UP or DOWN to change the settings.
The order for setting is: 12/24 hour format→Hour→Minute
Press SET button again to confirm.
If no buttons are pressed for more than 20 seconds, setting mode will be exited and returned to time mode.
(Note: When using the buttons to set the clock time, pressing UP or DOWN once will increase or decrease the
setting item one by one. By pressing and holding UP or DOWN buttons, the setting item will increase or decrease
by 8 units per second.)
TROUBLESHOOTING GUIDE
The thermometer doesn’t display anything.
➢Check the batteries in the thermometer and sensor.
Temperature from outdoor sensor not displayed.
➢Check that the distance between the thermometer
and sensor doesn’t exceed 30m.
➢Make sure that the devices are located at least 2m
from monitors and TV sets.
➢Avoid placing the devices on or close to window
frames made of metal.
➢Avoid using electronic devices such as loudspeakers
which operate at the same frequency (433MHz),
close to the devices.
➢Check the batteries in the thermometer and any
connected sensors.
➢Remove the batteries, wait a while and then reinsert
them.
Displayed temperature is not correct.
➢Remove the batteries, wait a while and then re-
insert them.
➢Make sure that the devices are not affected by heat
sources or air-conditioning units and such.
SUNNY
PARTLY CLOUDY
CLOUDY
RAINY
SNOWY

PRECAUTIONS
Do not clean any part of the product with benzene, thinner or other solvent chemicals. When necessary, clean it with
asoft cloth.
Never immerse the product in water. This will damage the product.
Do not subject the product to extreme force, shock, or fluctuations in temperature or humidity.
Do not tamper with the internal components.
Do not mix new and old batteries or batteries of different types.
Do not mix alkaline, standard or rechargeable batteries with this product.
Remove the batteries if storing this product for along period of time.
Do not dispose of this product as unsorted municipal waste. Collection of such waste separately for special
treatment is necessary.
Waste electrical and electronic equipment are a special waste category, collection,
storage, transport, treatment and recycling are important because they can avoid
environmental pollution and are harmful to health. Submitting waste electrical and
electronic equipment to special collection centers makes the waste to be recycled
properly and protecting the environment. Do not forget! Each electric appliance that
arrives at the landfill, the field, pollutes the environment!
Importer & distributor:
SC VITACOM ELECTRONICS SRL
CIF: RO 214527
Tel. [phone]*
[email protected], www.vitacom.ro