WARNING: Follow the safety instructions below for handling and maintaining batteries.
• Do not short circuit batteries.
• Do not keep batteries near re, sources of heat, or use in direct sunlight.
• Remove batteries from tool when not being used to an extended period of time.
• Never handle leaked batteries. Do not dismantle batteries.
• Recycle used tool and batteries at your local recycling facility.
• Remove the battery if the instrument is not being used for an extended period of time.
TROUBLESHOOTING GUIDE
CLEANING
INSTRUCTION MANUAL WARRANTY STATEMENT
BATTERY WARNINGS
Problem Possible Cause Solution
Incorrect measurement 1. Measuring surfaces are dirty
2. Preset data is incorrect
1. Clean the measuring surfaces
2. Reset instrument reading to ZERO
No display on LCD 1. Battery power is low
2. Battery is not properly installed
1. Replace with new CR2032 battery
2. Reinstall the battery, ensuring the
(+) side is facing up
Display is dim or ashing Battery power is low Replace with new CR2032 battery
WEN Products is committed to building tools that are dependable for years. Our warranties are consis-
tent with this commitment and our dedication to quality.
LIMITED WARRANTY OF WEN CONSUMER POWER TOOLS PRODUCTS FOR HOME USE
GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser only, that all WEN
consumer power tools will be free from defects in material or workmanship for a period of two (2) years
from date of purchase. Ninety days for all WEN products, if the tool is used for professional use.
SELLER’S SOLE OBLIGATION AND YOUR EXCLUSIVE REMEDY under this Limited Warranty and,
to the extent permitted by law, any warranty or condition implied by law, shall be the repair or replace-
ment of parts, without charge, which are defective in material or workmanship and which have not been
misused, carelessly handled, or misrepaired by persons other than Seller or Authorized Service Cen-
ter. To make a claim under this Limited Warranty, you must make sure to keep a copy of your proof of
purchase that clearly denes the Date of Purchase (month and year) and the Place of Purchase. Place
of purchase must be a direct vendor of Great Lakes Technologies, LLC. Third party vendors such as
garage sales, pawn shops, resale shops, or any other secondhand merchant void the warranty included
for repairs and transportation.
When returning a product for warranty service, the shipping charges must be prepaid by the purchaser.
The product must be shipped in its original container (or an equivalent), properly packed to withstand the
hazards of shipment. The product must be fully insured with a copy of the warranty card and/or the proof
of purchase enclosed. There must also be a description of the problem in order to help our repairs de-
partment diagnose and x the issue. Repairs will be made and the product will be returned and shipped
back to the purchaser at no charge.
This limited warranty does not apply to accessory items that wear out from regular usage over time
including belts, brushes, blades, batteries, etc.
Any implied warranties shall be limited in duration to two (2) years from date of purchase. Some states
in the U.S., Some Canadian provinces do not allow limitations on how long an implied warranty lasts, so
the above limitation may not apply to you.
In no event shall seller be liable for any incidental or consequential damages (including but not limited to
liability for loss of prots) arising from the sale or use of this product. Some states in the U.S. And some
Canadian provinces do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you.
This limited warranty gives you specic legal rights, and you may also have other rights which vary from
state to state in the U.S., Province to province in Canada and from country to country.
This limited warranty applies only to portable electric tools, bench power tools, outdoor power equipment
and pneumatic tools sold within the United States of America, Canada and the commonwealth of Puerto
Rico. For warranty coverage within other countries, contact the WEN customer support line.
After each use, wipe clean the instrument clean with a soft cloth. DO NOT use any type of solvent.
DO NOT immerse the instrument in liquid. Water damage may cause the display to fail. If this hap-
pens, wipe off the liquid and reset the instrument by removing the battery for 30 seconds. Then
reinstall the battery and turn the tool ON.
If the instrument fails to work, please contact our customer service at (800) 232-1195, M-F 8-5 CST
