Weslo WLEX31310.1 User manual

CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Keep this manual
for future reference.
USER'S MANUAL
Serial Number
Decal
Model No. WLEX31310.1
Serial No.
Write the serial number in the
space above for reference.
www.weslo.com
QUESTIONS?
If you have questions, or if parts are
damaged or missing, DO NOT
CONTACT THE STORE; please
contact Customer Care.
IMPORTANT: Please register this
product (see the limited warranty
on the back cover of this manual)
before contacting Customer Care.
CALL TOLL-FREE:
1-866-699-3756
Mon.–Fri., 6 a.m.–6 p.m. MT
Sat. 8 a.m.–4 p.m. MT
ON THE WEB:
www.wesloservice.com
Meijer.com

2
TABLE OF CONTENTS
WARNINGDECALPLACEMENT ..............................................................2
IMPORTANTPRECAUTIONS ................................................................3
BEFOREYOUBEGIN ......................................................................4
ASSEMBLY ...............................................................................5
HOWTOUSETHEEXERCISEBI E .........................................................11
MAINTENANCEANDTROUBLESHOOTING ...................................................15
FCCINFORMATION.......................................................................16
EXERCISEGUIDELINES ...................................................................17
PARTLIST ..............................................................................18
EXPLODEDDRAWING ....................................................................19
ORDERINGREPLACEMENTPARTS ..................................................BackCover
LIMITEDWARRANTY ..............................................................BackCover
WESLO is a registered trademark of ICON IP, Inc.
WARNING DECAL PLACEMENT
This drawing shows the location(s) of the warning
decal(s). If a decal is missing or illegible, see
the front cover of this manual and request a
free replacement decal. Apply the decal in the
location shown. Note: The decal(s) may not be
shown at actual size.
Meijer.com

3
WARNING: To reduce the risk of serious injury, read all important precautions and
instructions in this manual and all warnings on your exercise bike before using your exercise bike.
ICON assumes no responsibility for personal injury or property damage sustained by or through the
use of this product.
1. Before beginning any exercise program,
consult your physician. This is especially
important for persons over age 35 or per-
sons with pre-existing health problems.
2. Use the exercise bike only as described in
this manual.
3. It is the responsibility of the owner to ensure
that all users of the exercise bike are ade-
quately informed of all precautions.
4. The exercise bike is intended for home use
only. Do not use the exercise bike in a com-
mercial, rental, or institutional setting.
5. Keep the exercise bike indoors, away from
moisture and dust. Do not put the exercise
bike in a garage or covered patio or near
water.
6. Place the exercise bike on a level surface
with at least 2 ft. (0.6 m) of clearance around
the exercise bike. To protect the floor or
carpet from damage, place a mat under the
exercise bike.
7. Inspect and properly tighten all parts regu-
larly. Replace any worn parts immediately.
8. Keep children under age 12 and pets away
from the exercise bike at all times.
9. Wear appropriate clothes while exercising;
do not wear loose clothes that could become
caught on the exercise bike. Always wear
athletic shoes for foot protection.
10. The exercise bike should not be used by
persons weighing more than 250 lbs.
(113 kg).
11. The heart rate monitor is not a medical
device. Various factors, including the user's
movement, may affect the accuracy of heart
rate readings. The heart rate monitor is
intended only as an exercise aid in determin-
ing heart rate trends in general.
12. The exercise bike does not have a free
wheel; the pedals will continue to move until
the flywheel stops. Reduce your pedaling
speed in a controlled way.
13. Always keep your back straight while using
the exercise bike; do not arch your back.
14. Over exercising may result in serious injury
or death. If you feel faint or if you experience
pain while exercising, stop immediately and
cool down.
IMPORTANT PRECAUTIONS
Meijer.com

4
Thank you for selecting the new WESLO®PURSUIT
CT 1.5 exercise bike. Cycling is an effective exercise
for increasing cardiovascular fitness, building
endurance, and toning the body. The PURSUIT CT 1.5
exercise bike provides a selection of features
designed to make your workouts at home more effec-
tive and enjoyable.
For your benefit, read this manual carefully before
you use the exercise bike. If you have questions
after reading this manual, please see the front cover
of this manual. To help us assist you, note the product
model number and serial number before contacting
us. The model number and the location of the serial
number decal are shown on the front cover of this
manual.
Before reading further, please review the drawing
below and familiarize yourself with the labeled parts.
Resistance nob
Water Bottle Holder*
Seat
Seat Post nob
Pedal/Strap
Leveling Cap
Console
Heart Rate Monitor
Handlebar
BEFORE YOU BEGIN
*Water bottle is not included
Length: 2 ft. 9 in. (84 cm)
Width: 1 ft. 8 in. (51 cm)
Weight: 66 lbs. (30 kg)
Meijer.com

5
ASSEMBLY
To hire an authorized service technician to assemble the exercise bike, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and pliers .
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M8 Split
Washer (50)–3
M8 Locknut
(10)–6
M4 x 15mm
Screw (48)–6
M8 x 15mm Patch
Screw (34)–3
M10 x 70mm Patch Screw (33)–2
M8 x 60mm Patch Screw (30)–4 M8 x 65mm Bolt (49)–2
Meijer.com

6
1.
Insert the Rear Stabilizer (6) into the Frame (1).
Attach the Rear Stabilizer with four M8 x 60mm
Patch Screws (30).
6
30
1
2. See the inset drawing. Remove the screw and
the cardboard tube from the Frame (1). Discard
the screw and the cardboard tube.
Orient the Front Stabilizer (2) so that the large
holes face the Frame (1).
Attach the Front Stabilizer (2) to the Frame (1)
with two M10 x 70mm Patch Screws (33).
1
1
2
33 2
Large
Holes
To make assembly easier, read the
information on page 5 before you begin.
1
Screw
Cardboard
Tube
Meijer.com

7
3
3. While a second person holds the Upright (13)
near the Frame (1), connect the Extension Wire
(23) to the Reed Switch Wire (39).
Next, connect the Resistance Cable (19) to the
Lower Resistance Cable (29) in the following
way:
•See drawing A. Pull upward on the metal
bracket on the Lower Resistance Cable (29),
and insert the tip of the Resistance Cable (19)
into the wire clip inside the metal bracket.
•See drawing B. Firmly pull the Resistance
Cable (19) upward and slide it into the top of
the metal bracket.
•See drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Insert the wires and cables downward into the
Frame (1).
Tip: Avoid pinching the wires and cables.
Insert the Upright (13) into the Frame (1).
Attach the Upright (13) with three M8 x 15mm
Patch Screws (34) and three M8 Split Washers
(50).
Avoid pinching the
wires and cables
39
19
29
34 50 50
23
13
1
34
ABC
29
19
19 Metal
Bracket
Metal
Bracket
29
Meijer.com

8
5. The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the screw, remove the battery
cover, and insert the batteries into the battery
compartment. Make sure to orient the batter-
ies as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
5
Batteries
Screw Battery
Cover
16
4
4. Attach the Handlebar (42) to the Upright (13)
with two M8 x 65mm Bolts (49) and two M8
Locknuts (10).
Attach the Water Bottle Holder (3) to the Upright
(13) with two M4 x 15mm Screws (48).
3
13
49
10
48
42
Meijer.com

9
7
6
6. While a second person holds the Console (16)
near the Upright (13), connect the wire on the
Console to the Extension Wire (23).
Insert the excess wire into the Upright (13) or
into the Console (16).
Tip: Avoid pinching the wires. Attach the
Console (16) to the Upright (13) with four M4 x
15mm Screws (48).
48
16
13
23
7. Attach the Seat (12) to the Seat Post (5) with
four M8 Locknuts (10). Note: The Locknuts
may be preattached to the underside of the
Seat.
5
10
12
Avoid pinching
the wires
Meijer.com

10
10. Make sure that all parts are properly tightened before you use the exercise bike. Note: After assembly
is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor.
9. Identify the Left Pedal (24), which is marked
with an “L.”
Using an adjustable wrench, firmly tighten the
Left Pedal (24) counterclockwise into the left
arm of the Crank (21).
Tighten the Right Pedal (not shown) clockwise
into the right arm of the Crank (not shown).
Adjust the strap on the Left Pedal (24) to the
desired position, and press the end of the strap
onto the tab on the side of the Left Pedal.
Adjust the strap on the Right Pedal (not
shown) in the same way.
9
24
Strap
Tab
21
8. Loosen and remove the Seat Post nob (9)
from the Frame (1).
Insert the Seat Post (5) into the Frame (1).
Adjust the Seat Post to the desired height, and
insert the Seat Post nob (9) through the indi-
cated hole in the Frame into one of the
adjustment holes in the Seat Post.
Tighten the Seat Post nob (9). Make sure that
the Seat Post Knob is firmly engaged in one
of the adjustment holes in the Seat Post (5).
5
1
9
Hole
Adjustment
Holes
8
Meijer.com