West Elm bergen closet wide 1 drawer User manual

bergen closet wide 1 drawer
assembly instructions
Page 1 of 69181330 / 9181314 - 04/07
A B
large cam lock 8x
D
C
small dome screw 2x
F
H
E
L
K
O
mounting plate 1x
large screw 4x
felt pad 6x
smalll screw 6x
small cam lock 4x
drawer glide 2x
! Tools required:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect nish.
wooden dowel 8x
cam screw 12x
drawer handle with screws 1x
M

bergen closet wide 1 drawer
assembly instructions
Page 2 of 69181330 / 9181314 - 04/07
1. Fasten drawer glides (K) to side panels using small screws (F). Tighten screws with phillips screwdriver. Be sure to insert
screws through the correct holes on each glide as shown .
2. Insert large cam locks (B) into holes of side panels. Turn cam locks with a phillips screwdriver so that the arrow on top is
pointing out.
3. With a hammer gently tap wooden dowels (D) into holes in side of panels.
B
D
F
K
Left
Right
Left
top edge top edge

bergen closet wide 1 drawer
assembly instructions
Page 3 of 69181330 / 9181314 - 04/07
A
4. Insert cam screws (A) into top and bottom panels as shown and tighten with phillips screwdriver.
5. Fasten side panels to bottom panel. Fit cam screws into cam locks and tighten using phillips screwdriver.
6. Slide back panel into groove. Make sure panel slides all the way into the bottom panel groove.

bergen closet wide 1 drawer
assembly instructions
Page 4 of 69181330 / 9181314 - 04/07
7. Fasten top panel to side panels. Fit cam screws into cam locks and tighten using phillips screwdriver. Attach felt pads (O) to
base.
8. Insert cam screws (A) into drawer front panel as shown and tighten with phillips screwdriver.
9. Fasten drawer side panels to drawer front panel. Insert small cam locks (C) into side panels. Fit cam screws into cam locks and
tighten using phillips screwdriver.
A
C
O

bergen closet wide 1 drawer
assembly instructions
Page 5 of 69181330 / 9181314 - 04/07
10. Slide drawer bottom panel into grooves as shown. Gently insert back panel into sides and secure using large screws (L).
Tighten screws with a phillips screwdriver.
11. Pull out drawer glides and t drawers into drawer glides. Fasten drawer to glide from inside the drawer using small dome
screws (E).
12. Fasten handle (H) to drawer using the 2 screws supplied with each handle.
L
E
H

bergen closet wide 1 drawer
assembly instructions
Page 6 of 69181330 / 9181314 - 04/07
13. Multiple units can be attached together as shown using small screws (F) and mounting plates (M).
CARE INSTRUCTIONS
Hardware may loosen over time. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect nish, avoid the use of chemicals and household cleaners.
F
M