RTS Series
Installation Quick Guide
STEP 1: DOOR TEMPLATE
STEP 3: UNIT HANDLES
1. Fold the template and ensure
it is square to the door.
2. Bore two 3/8” holes through
the door at A.
2. Tighten the handle screw with
a screwdriver, so the handle is firmly
held in place.
STEP 2: LATCH
1. Using the parts from Bag A,
insert the latch into the hole on
the edge of the door and screw
into place. Make sure that the
center of the spindle hole is in
the center of the drilled 2 1/8” hole.
1. Using the screws from Bag B, install
the handles onto the inside unit and
outside unit based on your right/left
handed configuration.
3. Feed the outside unit cable
underneath the latch and align
the fixing posts with the two
corresponding holes in the latch.
Outside unit
for Step 4
STEP 4: MOUNTING OUTSIDE UNIT
1. Align the marks on
the hub as shown in
top image.
2. Attach the outside
rubber gasket to the
back of the outdoor
unit.
Outside
gasket for
Step 4
2. Screw the included strike
plate into the doorjam.
