Wharfedale Pro DM4.0 User manual

FEATURES
+Frequency response tailored for voice for clear vocal reproduction
+Uniform super-cardioid pickup pattern isolates the main sound source and minimizes
background noise
+Features high output, fast transients and clean articulation
+Dent resistant spring steel grille
+Low handling noise
APPLICATIONS
+ Live Stage
Clubs
Houses of Worship
Corporate
Presentations
Karaoke
+ Instruments
Electric guitar amplifiers
drums, horns, percussion
+ Home Studio
All vocal and instrument applications
The DM4.0 and DM4.0S are available either as a single mic,
or as a pack of three microphones. The single pack contains
one microphone with stand adaptor as well as a 4.5 meter
XLR-XLR cable. The pack of microphones is supplied in a hard
wearing carry case and contains three microphones with
stand adaptors and screws.
*Also available are the DM2.0 & 2.0S,
DM3.0 & 3.0S and DM5.0 & 5.05!
Super Cardioid
Dynamic
Microphone
DM4.0 & DM4.0S
DM4.0_Brochure RevC.indd 1 10/18/06 5:19:24 PM

POLAR CHARTS
The frequency response curve shown above
(measuring response at +3dB) and polar
pattern correspond to typical production run
specifications for this microphone.
OVERVIEW
The DM4.0 is a dynamic moving coil microphone designed to handle a wide variety of vocal and instrument
applications for both live sound and recording. This microphone is also available with an integral on/off
switch (model DM4.0S). Characteristics of the DM4.0, such as a tight super-cardioid pickup pattern with a
frequency response of 45Hz – 18kHz, slight bass proximity and mid range presence result in a warm and
natural sounding response for every application. The DM4.0 is engineered to handle very high source levels
without distortion and provides over 36dB of off axis feedback rejection.
Low impedance and balanced output allow for interference free performance. The DM4.0 is built solidly
with a cast alloy body, steel mesh grille ball and internal pop screen.
SPECIFICATIONS
Transducer Type: Dynamic
Frequency Response: 45Hz−18KHz
Polar Pattern: Super-cardioid
Output Impedance: 250ohms
Sensitivity: –53dB (0dB=1V/Pa)
Off-axis rejection: >26dB at 125o
Maximum SPL: >136dB
Cable/Connector: 3 pin gold plated male XLR
Polarity: Positive voltage on pin 2
relative to pin 3 of output
XLR connector
Housing: Zinc alloy
Weight: 330 grams/11.75 oz.
www.wharfedalepro.com
IAG House, Sovereign Court,Ermine Business Park, Huntingdon, Cambs P E29 6XU England
Tel: [phone] Fax: [phone]
The information in this brochure is subject to change without notice. All rights reserved. © 2006 Wharfedale Pro. Wharfedale Pro is a member of the International Audio Group.
DM4.0_Brochure RevC.indd 2 10/18/06 5:19:24 PM