Whelen Engineering Company Micro-Max Beam User manual

ROUTE 145, WINTHROP ROAD
CHESTER, CONNECTICUT 06412-0684
TELEPHONE: [phone]
FAX: [phone]
®
ENGINEERING COMPANY, INC.
Installation Guide / Micro-Max Beam
©2000 Whelen Engineering Company Inc.
Form No.13534 (051500)
Installation:
WARNING: All customer supplied wires must be sized to
supply at least 125% of the maximum operating current, and
fused at the battery, to carry that load.
WARNING: The strobe power supply is a high voltage
device. DO NOT TOUCH the strobe tube assembly or
power supply assembly while the unit is in operation. WAIT
10 MINUTES after turning power off to starting any work or
trouble shooting.
IMPORTANT: Overall mounting depth for this light must be
at least two inches. Mounting surface must be flat.
IMPORTANT: After marking the mounting holes using the
supplied template, always check all measurements
before cutting and drilling. Although the template is to
scale, paper can stretch or shrink.
1. First check behind the proposed mounting area. You
must have at least 2 inches clearance behind the light
head, and the mounting surface must be flat.
2. Using the template supplied, mark off the mounting holes
and lighthead cut-out hole onto the mounting surface.
3. Drill the 4 screw holes and cut the mounting hole out as
indicated on the template.
4. Wire the lighthead as shown, then secure it to the
mounting location using the supplied sheet metal screws.
NOTE: This light is designed to be utilized with all
Whelen Universal Power Supplies.
123
9 10
Cut shield off flush
with cable jacket.
A/R 68-1180646-10
A/R 68-1180646-20
A/R 68-1180646-30
A/R 68-1180646-40
168-1180646-50
02-0361112-00
1
3
4
5
6
7
8
MICRO-MAX-BEAM LENS / AMBER
MICRO-MAX-BEAM LENS / BLUE
MICRO-MAX-BEAM LENS / CLEAR
MICRO-MAX-BEAM LENS / GREEN
MICRO-MAX-BEAM LENS / RED
MICRO-MAX-BEAM STROBE ASSEMBLY
DESCRIPTION
PART NUMBER
01-0661275-00
-
QTY. ITEM
-MICRO-MAX-BEAM / LIGHTHEAD ASSY.
A/R 01-0440624-15
A/R 01-0440624-20
9
10
15' EXTENSION CABLE ASSEMBLY
20' EXTENSION CABLE ASSEMBLY
123 Position 3 = WHITE
Position 2 = BLACK
Position 1 = RED
#6x11/4"
PPHSMS
3 4 5
67
8

3.562
1.187
2.375
1.406
4 MOUNTING HOLES FOR #6 X 1-1/4" PPH SMS
1.781
1.550
IMPORTANT: This template may not be exactly to scale.
After marking off mounting dimensions, always check all
measurements before cutting.
TM
MICRO MAX BEAM
TEMPLATE
1.781
2.812
1.550
(CUT-OUT THIS AREA)
(CUT-OUT THIS AREA)
(CUT-OUT THIS AREA)