Page 2
wire passage
/drain hole
mounting surface
bracket
SA315
1/4
(Speaker & Bracket)
- 20 X 1-1/2"
HEX HEAD SS
1/4 X 20 X 1-1/4
HEX HEAD (Speaker Only)
1/4" SPLIT
LOCK WASHER
1/4" SPLIT
LOCK WASHER
1/4 - 20 x 7/16 HEX HEAD CAP SCREW
1/4 - 20 X 7/16
HEX NUT SS
SA315 / Rear View
wire
exit &
drain
hole
A
A
A A
IMPORTANT: The SA315 speaker mounting kit comes with 3 long bolts (1/4-20 X 1-1/2” Hex
Head SS). The longer bolts are necessary to go through the mounting bracket, the speaker
housing and into the siren driver. They will replace 1 of the 2 shorter bolts (“A”) that now secure
the siren driver to the speaker housing. This speaker will be shipped with 2 of the shorter bolts
installed. The short bolt must be used in the hole that does not go through the bracket so it will
properly secure the driver to the housing. If you need to remove all 4 bolts at once be sure to
hold the driver securely in place.
WARNING: For drainage purposes, the speaker must be oriented so that the wire
passage hole is in the “6 o’clock” position (closest to the road). This hole also serves
as the drain hole for the speaker. Improper mounting will result in premature driver
failure and void the product warranty.
IMPORTANT! It is the responsibility of the installation technician to make sure that
the installation and operation of this product will not interfere with or compromise
the operation or efficiency of any vehicle equipment! Before you
return this vehicle to active service, visually confirm the proper
operation of this product, as well as all vehicle components and
equipment.
1/4" SPLIT
LOCK
WASHER
1/4" SPLIT
LOCK
WASHER
1/4" SPLIT
LOCK
WASHER
1/4" SPLIT LOCK WASHER
CAUTION
Loud siren noise can cause
hearing damage and/or loss.
Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!
Wear
Protection!
ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!
DANGER! Sirens produces extremely loud emergency
warning tones! Exposure to these tones without proper and
adequate hearing protection, could cause ear damage and/or
hearing loss! The Occupational Safety & Health Administration
(www.osha.gov) provides information necessary to determine
safe exposure times in Occupational Noise Exposure Section
1910.95. Until you have determined the safe exposure times for
your specific application, operators and anyone else in the
immediate vicinity should be required to wear an approved
hearing protection device. FAILURE TO FOLLOW THIS
RECOMMENDATION COULD CAUSE HEARING LOSS!
wire passage
/drain hole
mounting surface
bracket
SA315
1/4
(Speaker & Bracket)
- 20 X 1-1/2"
HEX HEAD SS
1/4 X 20 X 1-1/4
HEX HEAD (Speaker Only)
1/4" SPLIT
LOCK WASHER
1/4" SPLIT
LOCK WASHER
1/4 - 20 x 7/16 HEX HEAD CAP SCREW
1/4 - 20 X 7/16
HEX NUT SS
SA315 / Rear View
wire
exit &
drain
hole
A
A
A A
IMPORTANT: The SA315 speaker mounting kit comes with 3 long bolts (1/4-20 X 1-1/2” Hex
Head SS). The longer bolts are necessary to go through the mounting bracket, the speaker
housing and into the siren driver. They will replace 1 of the 2 shorter bolts (“A”) that now secure
the siren driver to the speaker housing. This speaker will be shipped with 2 of the shorter bolts
installed. The short bolt must be used in the hole that does not go through the bracket so it will
properly secure the driver to the housing. If you need to remove all 4 bolts at once be sure to
hold the driver securely in place.
WARNING: For drainage purposes, the speaker must be oriented so that the wire
passage hole is in the “6 o’clock” position (closest to the road). This hole also serves
as the drain hole for the speaker. Improper mounting will result in premature driver
failure and void the product warranty.
IMPORTANT! It is the responsibility of the installation technician to make sure that
the installation and operation of this product will not interfere with or compromise
the operation or efficiency of any vehicle equipment! Before you
return this vehicle to active service, visually confirm the proper
operation of this product, as well as all vehicle components and
equipment.
1/4" SPLIT
LOCK
WASHER
1/4" SPLIT
LOCK
WASHER
1/4" SPLIT
LOCK
WASHER
1/4" SPLIT LOCK WASHER
CAUTION
Loud siren noise can cause
hearing damage and/or loss.
Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!
Wear
Protection!
ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!
DANGER! Sirens produces extremely loud emergency
warning tones! Exposure to these tones without proper and
adequate hearing protection, could cause ear damage and/or
hearing loss! The Occupational Safety & Health Administration
(www.osha.gov) provides information necessary to determine
safe exposure times in Occupational Noise Exposure Section
1910.95. Until you have determined the safe exposure times for
your specific application, operators and anyone else in the
immediate vicinity should be required to wear an approved
hearing protection device. FAILURE TO FOLLOW THIS
RECOMMENDATION COULD CAUSE HEARING LOSS!
