installation
Each Whip Mix Water Bath is packaged as follows:
1 – Water Bath unit
1 – Removable pan
Fill the removable pan with water to the water level indicator line.
Place removable pan in the Water Bath Unit by positioning the pan into the opening and rotating
the two clips over the lip of the pan.
Wrap gauze around the Lift Tray (see Accessories) to prevent materials such as impression
compound from sticking to the tray and removable pan surfaces.
Plug the unit into a grounded receptacle having the same electrical characteristics as shown
on the Water Bath data plate.
enviRonmental conditions
This Water Bath has been designed to be safe at least under the following
environmental conditions:
of the normal voltage.
opeRation
Turn the unit on by pushing the green on/off switch. NOTE:The unit will not turn on until the
removable pan is correctly positioned in the Water Bath Unit.
NOTE:
is reached.
for increased heat or to decrease.
will show the actual temperature.
green on/off switch. Remove the lift tray from the removable pan if being used and discard gauze.
Autoclave lift tray and removable pan.
tecHnical speciFications
Voltage: 115 V/60 Hz
Amperage: 1.5 A
Wattage: 175 W
Weight: 5 lbs. (2.3 kg)
maintenance
Unplug the unit before performing any maintenance or repair.
Keep the gasket on top of unit free of debris so that any spilled water does not enter the area
containing the electrical components.
caUtion
the water to evaporate and the unit to overheat.
Use only in a properly grounded outlet.
WARNING: Allowing this appliance to operate without water or with damage
to the thermostat bulb or tube can cause the unit to overheat, causing damage
to the unit, shock or fire hazard.
maintenance or repair.
17125_Water_Bath_Manual.indd 2 4/26/11 10:33 AM