Whirlpool LA5300XP User manual

AUTOMATIC
WASHER
Design 2000”
Large Capacity
Model
LA53OOXP
wave Ovens Trash Compactors Room Air Condltloners Oehumldillers Aulomatlc Washers. Clothes Oryers Freezers. Relqerator-Freeze

Parts and features
LAUNDRY TEMPERATURE
ODEL AND SERIAL
\
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Copy your Model and Serial Numbers here
When youneed service or call with a ~ ---. -~
question, have this information ready.
Model Number
1. Complete Model and Serial Num-
bers (from plate under the lid near the
hinge). gx~;s-------~-
2. Purchase date from sales slip.
Copy this information in these spaces. Purchase Da’e
Keep this book in the Laundry Informa-
tion Center with your”Laundry Guide,”
sales slip and warranty
Service Company
Phone Number
2

Your responsibilitie s
Read this “Use and Care Guide”
and your “Laundry Guide” care-
fully for Important use and safety
informatton
You are personally responsible
for making sure that your
washer..
l is installed by a qualifiedinstaller.
l is properly installed and
leveled on a floor that can
support the weight.
l is connected to the right kind
of outlet, electric supply, water
supply and drain.’
l is properly grounded.”
l is used only for jobs normally
expected of home automatic
washers
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by chrldren or anyone
unable to operate it properly.
‘See the “Installation Instructions”
for complete information.
Contents
Page
PARTS AND FEATURES. 2
YOUR RESPONSIBILITIES 3
SAFETY FIRST 3
STARTING YOUR WASHER 4
WHAT HAPPENS IN EACH
CYCLE 6
OTHER OPERATING
INSTRUCTIONS 10
For a Rinse and Spin IO
For a Drain and Spin 10
For a Soak
Cleaning the Lint Pifter : : 10 10
CARING FOR YOUR WASHER 11
Winterizing 12
IF YOU NEED SERVICE OR
ASSISTANCE. 13
1 Before Calling for
Assistance
2. If You Need Assistance. : 13 14
3. If You Need Service 14
4. If You Have a Problem 14
801986 Whirlpool Corporation

Starting your washer
Before starting
your washer: 1 Measure and add detergent
2 Place sorted load In washer
3 Start washer.
Select a
1. LOAD SIZE
l Turn the knob to point at a setting
l Match the wash water temperature
that descri bes the size of load you to the type of fabrics and soils being
want to wash. washed.
l The water level can be set for
EX SMALL (a few items), MED or
LARGE (a full load).
l All rinses are cold.
Recommended wash temperatures
can be found in your”Laundry Guide”.
NOTE: Use the LARGE water level
for best permanent press results.
Select WATER
2. TEMPERATURES
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too 8
CAUTION:
little water can cause wear or DO NOT
tearing of load Items. OVERLOAD WASHER.
LARGE (17.3 gals. 65.5 L)’
‘Approximate MED (13.4 gals. 50.8 L)’
fill with load. EX SMALL (9.5 gals. 36.0 L)’

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows IO minutes of agitation in
the REGULAR Cycle.
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes

What happens in each cycle*
Each cycle has been designed for different kinds of fabrics. Numbers on the
dial in each cycle are the minutes of WASH agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer
fills before agitation and timing starts. After agitation starts, the knob turns clock-
wise until it points to OFF and the cycle ends
REGULAR HEAVY Cycle
REGULAR Cycle
A cycle for sturdily con-
structed fabrics that are
heavily soiled.
A cycle for regular loads of
fabrics that are moderately
soiled.
PERMANENT PRESS Cycle
1 A special cycle with the
necessary cool down rinse
which helps keep wrinkles
from setting into Permanent
Press and some synthetic
1 fabrics.
WASH
Selected
1
Time;
High
Speed

NOTE: You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles, cold water is sprayed on the spinning load to help
with the rinsing.
PARTIAL
DRAIN
(Pause)

SHORT C)rle
SOAK Cycle
Use for delicate Items that
need a short wash and
spin time Wash nylon hose
or panty hose In a net
laundry bag
Brief periods of agitation
and soak time help remove
heavy soils and certain
stains that need extra
pretreatment. Use recom-
niended amount of
detergent The SOAK Cycle
should always be fol-
lowed by a Wash Cycle.
a

Special care is needed when soaking or pre-washing laundry.
See your”Laundry Guide”for proper use of this cycle.
9

Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse )
9 Push Control Knob in.
l Turn clockwise to anyeon the dial.
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected level;
agitate 2 minutes; drain and spin.
For a soak
For best results, use warm water
for soaking stained laundry. Hot
water can set stains.
l Use recommended amount of
detergent or pre-soa k product.
For a drain and spin
Your washer can be set to drain
and spin out water
l Push Control Knob in
l Turn clockwise to the bar lust before
OFF In any cycle See above
drawing.
. Pull Control Knob out.
l The washer will drain and spin.
l Push Control Knob In.
l Turn clockwise to point of a number
in the SOAK Cycle...use the 6-minutes
mark for a pre-wash.’
l Pull Control Knob out to start washer
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“laundry Guide!’
l Set the washer and start the next
selected wash cycle.
*To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of lint build-up. c
To clean:
l Lift off the agitator barrel.
l Wash or wiDe the filter clean in the
bottom of <he agitator barrel. The
filter is not removable.
l Replace the agitator barrel and
10
snap into place.