Whirlpool LA5800XP User manual

AUTOMATIC
WASHER
pP&aP=ity
LA5800XP
and
LA5805XP
we Ovens, Trash Compactors, Room AIM Condltlonets. Oehumidlfiers. Automatic Washers, Clothes OrYerS. Free&%. RefriEerator-freeze’

Parts and features
LAUNDRY TEMPERATURE
SELECTOR MAGIC CLEAN ’
LINT FILTER
\ //3q/ KN”B
(not shown)
MODEL AND SERIAL
NUMBER PLATE
- (not shown)
J
LI
QUID BLEACH
DISPENSER
i&g-x
_ ,-/ . AGITATOR
BASKET
TUB
Remove the Consumer
1 Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
/
shipping.
Copy your Model and Serial Numbers here
When you need service or call with a
question, have this information ready: Model Number
1. Complete Model and Serial Num-
bers (from plate under the lid near the
hinge]. Serio, Number
2. Purchase date from sales slip.
Copy this information in these spaces. Purchase Date
Keep this book in the Laundry Informa-
tion Center with your “Laundry Guide,”
sales slip and warranty. service Company/
Phone Number
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
2

Your responsibilities
Read this ‘Use and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
information.
You are personally responsible
for making sure that your
washer.. .
l is installed by a qualifiedinstaller.
l is properly installed and
leveled on a floor that can
support the weight?
l is connected to the right kind
of outlet, electric supply, water
supply and drain?
l is properly grounded.*
l is used only for jobs normally
expected of home automatic
washers.
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
*See the”Installation Instructions”
for complete information.
Contents
Paoe
PARTS AND FEATURES : -
YOUR RESPONSIBILITIES.
SAFETY FIRST
STARTING YOUR WASHER
WHAT HAPPENS IN EACH
CYCLE
OTHER OPERATING
INSTRUCTIONS
For a Rinse and Spin
For a Drain and Spin
For a Soak or Pre-Wash
Liquid Bleach Dispenser
MAGIC CLEAN” Lint Filter
SUDS-MISER” System
(Model LA5805XP only)
CARING FOR YOUR WASHER
IF YOU NEED SERVICE OR
ASSISTANCE.
I. Before Calling for
Assistance
2. If You Need Assistance
3. If You Need Service
4. If You Have a Problem
a-
2
3
3
4
6
10
10
10
10
11
11
12
13
15
15
15
15
15
01984 Whirlpool Corporation -SAVE THESE INSTRUCTIONS - I
3

Starting your washer
Before starting your washer: I. Measure and add detergent.
2. Place sorted load in washer.
3. Start washer.
Select a Select WATER
1. LOAD SIZE
2. TEMPERATURES
l To change the setting on the LOAD
SIZE SELECTOR, turn the knob to RESET.
l Then turn the knob to point at a
setting that describes the size of the
load you want to wash.
. Set the knob anywhere on or be-
tween HAND WASHABLE (a few small
items) and EX LARGE (a full load).
See your “Laundry Guide” for details
on load sizes.
l Select wash and rinse water tem-
peratures by pushing a button.
l This drawing shows a warm wash
(top temperature) and cold rinse
(bottom temperature] selection.
Recommended wash temperatures
can be found in your “Laundry Guide”
and printed under the washer lid.
; LOAD SIZES AND WATER LEVELS
* For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too DO NOT
little water can cause wear or OVERLOAD WASHER.
$
t tearing of load items.
I
EX-LARGE (20.5 gals.177.6 L)’
I *Approximate MEDIUM (13.9 galsJ52.6 L)’
fill with load. HAND WASHABLE (7.8 gals.129.5 L)’

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
I \ ,
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes.
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
5

What happens in each cycle
Each cycle has different agitation and spin speeds designed for different
kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH
agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer
fills before agitationland timing starts.lAfter agitation starts, the knob turns
REGULAR HEAVY Cycle
REGULAR Cycle
A cycle for sturdily con-
structed fabrics that are
heavily soiled.
A cycle for regular loads of
fabrics that are moderately
soiled.
PERMANENT PRESS Cycle
A special cycle with the
necessary cool down rinse
which helps keep wrinkles
from setting into Permanent
Press and some synthetic
fabrics.
6

clockwise until it points to OFF and the cycle ends.
NOTE:You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles, cold water is sprayed on the spinning load to
helpwith the rinsing.
--
DRAIN
No
Agltatton
HIGH
DRAIN HIGH
m-l
Agl%ion ) 4Fgy )
----
PARTIAL
DRAIN
(Pause
about 2
Minutes]
DRAIN
No
Agitation
1
NOTE: Always use cold rinse water for
permanent press fabrics.

KNITS/GENTLE Cycle
SOAK AND PRE-w1 ASH Cycles
A cycle that gently washes
and spins delicate items
and washable knits.
Brief periods of agitation
and soak time help remove
heavy soils and certain
stains that need extra
pretreatment. Use recom-
mended amount of
detergent or pre-soa k
additive. The SOAK Cycle
should always be fol-
lowed by a Wash Cycle.

I
+Pre-wash setting begins here, (see pagelo).
Special care Is needed when soaklng or pre-washing laundry,
See your “laundry Guide” for proper use of this cycle.

Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.)
l Push Control Knob in.
l Turn clockwise to any l on the dial.
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water.
l Push Control Knob in.
l Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l Pull Control Knob out.
l The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6 -9.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
l Use recommended amount of
detergent or pre-soak product.
l Push Control Knob in.
l Turn clockwise to point at a number
in the SOAK Cycle.’
l Pull Control Knob out to start washer.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide!’
10
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.