Whirlpool LA5OOOXP User manual

Ii
I
AUTOMATIC
WASHER
Design 2000 @
p&Capacity
LA5OOOXP
#aye Ovens. Trash Compactors. Room Au Condltloners. Oehumldlflers. Automatic Washers, Clothes Dryers. Freezers. Refrigerator-Freeze1

Parts and features
LAUNDRY TEMPERATURE
MODEL AND SERIAL
NUMBER PLATE
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Copy your Model and Serial Numbers here
When youneed service or call with a
question, have this information ready:
Model Number
1. Complete Model and Serial Num-
bers(from plate underthe lid nearthe
hinge]. Ser,o, Number
2. Purchase date from sales slip.
Copy this information in these spaces. Purchase Date
Keep this book in the Laundry Informa-
tion Center with your”Laundry Guide,”
sales slip and warranty.
Serwce Company /
Phone Number
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
2

‘sponsibilities
Read this “U&and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l is installed by a qualifiedinstaller.
l is properly installed and
leveled on a floor that can
support the weight.’
9 is connected to the right kind
of outlet, electric supply, water
supply and drain.*
l is properly grounded.’
l is used only for jobs normally
expected of home automatic
washers.
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
*See the “Installation Instructions”
for complete information
Contents
Page
PARTS AND FEATURES.
YOUR RESPONSIBILITIES.
SAFETY FIRST
STARTING YOUR WASHER
WHAT HAPPENS IN EACH
CYCLE.
OTHER OPERATING
INSTRUCTIONS
For a Rinse and Spin
For a Drain and Spin
Fora Soak
Cleaning the Lint Filter
CARING FOR YOUR WASHER
Winterizing
IF YOU NEED SERVICE OR
ASSISTANCE.
I. Before Calling for
Assistance
2. If You Need Assistance
3. If You Need Service
4. If You Have a Problem
-2
3
3
4
6
B
8
8
8
8
9
10
11
11
11
11
11
01985 Whirlpool Corporation

Starting your washer
your washer
1 Measure and add detergent
2 Place sorted load In washer
3 Start washer
Select a
I. L0.4D SIZE Select W.4TER 2. TEMPER,4TL7RES
l Turn the knob to point at a setting g Match the wash water temperature
that describes the size of load you
want to wash to the type of fabrics and
soils being
woshed
l The water level can be set for SMALL
(a few items) or LARGE (a full load).
See your “Laundry Guide” for details
on load sizes.
l All rtnses are cold
Recommended wash temperatures
con be found in your”Laundry Guide”.
LOAD SIZES AND W:4TER LEk’ELS
For best cleaning results, the
load must be able to move freely
in the water Too big a load or too
little water can cause wear or
tearing of load items
DO NOT
OVERLOAD WASHER.
*Approximate
fi!l with load.
I
LARGE (17.2 gals./651 L)’
I SMALL (9.5
galsJ36.0 L)’

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
B. Stop on a number in the cycle
you wont. The numbers are min-
utes of wash time. The drawing
shows 14 minutes of agitation in
the REGULAR HEAW Cycle. Note:
lhe washer will fill only when
the knob points within a FILL
area.
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes.
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What happens in each cycle*
Each cycle has been designed for different kinds of fabrics. Numbers on the
dial in each cycle are the minutes of WASH agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer
fills before agitation and timing starts. After agitation starts, the knob turns clock-
wise until it points to OFF and the cycle ends.
REGULAR HEAVY Cycle
A cycle for sturdily con-
strutted fabrics that are
heavily soiled.
REGULAR Cycle
A cycle for regular loads of
fabrics that are moderately
soiled.
KNITS/GENTLE Cycle
SOAK Cycle
A cycle that gently washes
and spins delicate items
and washable knits.
Brief periods of agitation
and soak time help remove
heavy soils and certain
stains that need extra
pretreatment. Use recom-
mended amount of
detergent. The SOAK Cycle
should always be fol-
lowed by a Wash Cycle.

NOTE: You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles, cold water is sprayed on the spinning load to help
with the rinsing.
bAgTEn )
SPIN
No High
Speed
4 Spray
Rinses
SOAK
4
1
Minutes
No
4gitation
I
Special care is needed when soaking or pre-washing laundry.
See your”laundry Guide”for proper use of this cycle. I

Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.)
l Push Control Knob In
l Turn clockwlse to any .on the dial
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water.
l Push Control Knob in.
. Turn clockwise to Ihe bar just before
OFF in any cycle. See above
drawing.
l Pull Control Knob out
. The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6and 7.
For a soak
l Push Control Knob in.
l Turn clockwise to point at a number
in the SOAK Cycle...use the &minutes
mark for a pre-wash?
l Pull Control Knob out to start washer.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
For best results, use warm water always be followed by a Wash
for soaking or pre-washing stained Cycle.
laundry. Hot water can set stains. Important: See additional care
l Use recommended amount of information on page 7 of your
detergent or pre-soak product. “Laundry Guide!’
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of llnt build-up.
To clean:
l Lift off the agitator barrel.
l Wash or wipe the filter clean in the
bottom of the agitator barrel. The
ftlter Is not removable.
l Replace the agitator barrel and
snap into place.
0

Caring for your was
WHEN NOT WASHING, keep both
water faucets turned off. This takes
the pressure off the water inlet valve
and hoses.
REMOVE SHARP OBJECTS such as pins,
buckles, etc., from clothes before
washing. Close metal zippers.
n
AFTER WASHING, use a soft dry cloth
to wipe the outside and inside dry.
Leave the lid up until the basket is dry.
SHARP OR HEAVY OBJECTS should
never be put on or in the washer.
Check pockets for bolts, nuts,
tools, etc.
Wipe up spills right away. Spills can
dull or damage the finish.
SOME PRETREATMENT PRODUCTS
can damage washer and dryer dials
consoles and finishes. Do not use
.L ~. -.
mese proaucrs on or near your
washer or dryer.

Winterizing
Because some water stays In the washer, freez-
lng can cause a lot of damage If your washer is
stored or moved during the cold weather
1. Shut off both water 2. Put a quart of
faucets. Discon- automoblle-type
nect and drain antifreeze In the
water Inlet hoses basket
To use the washer again.. .
-
1. Flush water pipes and hoses
2. Connect hoses to the washer
3. Turn on the water faucets
3. Set the washer for a
DRAIN and SPIN
[see page 8). Let It
run for about 30
seconds to mix the
antifreeze and
water
4. Run the washer
through a com-
plete cycle with
one cup Of deter-
gent to clean out
the antifreeze
IO