Whirlpool W10295370 User manual

Water Filter Installation Instructions
Follow these simple instructions for your lter type.
Refrigerator Water Filter 1
1. Locate the lter door in the right side of the refrigerator ceiling.
2. Press in the tab on the lter cover door to release the door latch
3. During initial installation of the water lter, remove the blue bypass cap located
in the refrigerator and retain for later use. During replacement installation rotate
the used lter counter clockwise until it is released from the lter head.
Note: there may be some water in the lter and some spilling may occur.
4. Remove the sealing label from the end of the lter and insert into the lter head.
Do not tamper with the lter cap. Rotate gently clockwise until the lter stops.
5. Lift the lter up into the compartment. Close the lter door completely.
6. Reduce water spurts by ushing air from the system. Run water continuously
for 4 gallons (approximately 5 minutes) through the dispenser until water runs
steady. Additional ushing may be required in some households where water is
of poor quality.
Part W10295370
Phone:
US: 1-866-698-2538
Hours of operation:
Monday – Friday 8:00 AM – 8:00 PM EST
TM