Whispbar K881W User manual

K881W
Fitting Kit
EN Fitting Instructions for Basic Carrier
ES Instrucciones de montaje para el sistema
de transporte
FInstructions de montage pour Basic Carrier
x 4 x 4 x 4 x 4
x 4 x 1 x 4 x 4
Revision No: 2A 1

Fitting Kit K881W
MAX kgs (lbs)
W/P WHD
Dodge
Durango , 5dr SUV 11-+ US 68 kgs (149 lbs) 68 kgs (149 lbs)
2

Fitting Kit EN
K881W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●This kit fits type A, B, C and D.
●Use keys to remove covers.
3

Fitting Kit EN
K881W
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Attaches to factory-fitted mounting points
●Please check the rear of this manual for
information relating specifically to your
vehicle.
●Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
4

Fitting Kit EN
K881W
●Tighten adjusting screw to 3 Nm (2.2 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
5

Fitting Kit EN
K881W
●Thread a plate onto the end of each
grubscrew approximately 10mm.
●Thread a locking nut onto each grubscrew.
●Use the 3mm allen wrench (provided with
kit) and the 10mm spanner wrench
(provided with bars) to tighten the locking
nut.
6

Fitting Kit EN
K881W
●Tighten the plate to the locking nut.
●Assemble as shown.
●Apply protective strip as shown.
●Assemble as shown.
7

Fitting Kit EN
K881W
Removal of crossbars
●Locate thumbscrews on all 4 corners of the
vehicle.
●Loosen all thumbscrews.
●Slide bar out by pushing it towards the
center of the vehicle.
Fitment
●Locate slot on rail.
8

Fitting Kit EN
K881W
●Slide the screw assembly as far as it will go
into the narrow end of the slot.
●Assemble as shown.
●Fit rubber pad (supplied with crossbar) to
foot.
●Make sure the pad fits into the holes
underneath the foot.
●Repeat for all legs.
9

Fitting Kit EN
K881W
●Place crossbars on pads ensuring the pads
fit into the holes underneath the foot and
the grubscrew passes through the hole in
the foot.
●Place washer over clamp thread as shown.
●Ensure that tab is inserted into clamp
block.
●Tighten the plastic knob. The side with the
nut showing should be facing up.
10