WHITE MARQUEE FANMASTER Manual

FANMASTER HEATER
INFORMATION SHEET
General Information
The Fanmaster is an industrial air heater specifically designed for use in well ventilated indoor areas. The unit
runs on a 8.5kg propane gas cylinder.
Operating Instructions
TO START AND USE
1. Plug in the mains lead to a wall socket.
2. Press the ON-OFF switch on. Let the motor fan run at least 230 seconds to check if the fan works properly
and/or to purge any fuel gas left from the last use.
3. With the hose attached to the gas inlet open the gas valve on the cylinder slowly. Be sure there is no gas
leakage.
4. Push in and hold the safety start valve button. Push ignition button repeatedly until the burner lights. If
the heater does not light within 10 seconds, wait a minimum of 3 minutes before retrying the correct
ignition circuit.
5. After the burner lights, keep the safety start valve button depressed for at least 5 seconds then slowly
release and the heater will continue to operate.
SAFETY
•Keep area clean and well lit.
•Keep children and bystanders away whilst operating the heater.
•Do not expose heaters to rain or wet conditions
•Do not spray aerosols in the vicinity of the heater.
•Do not place articles on or against the heater.
•Not for domestic use.
•Use ONLY in well ventilated areas.
•Gas cylinder to be place on the side of the heater unit, NOT in front or behind.
•Be sure that the heater is only used with the correct ventilation. Make sure that no object may
obstruct the fan air intake.

TROUBLESHOOTING
PROBLEM
CAUSE
REMEDY
Fan doesn’t work.
1. No electricity.
2. Blade stalled by housing.
1. Check power Supply
2. Call White Marquee
Piezo will no ignite.
1. Ignition cable damaged.
2. Ignition cable disconnected.
3. Distance between electrode and
burner too large.
1. Call White Marquee
2. Call White Marquee
3. Adjust distance within 3-8min
No gas.
1. Gas cylinder is empty.
2. Gas valve on cylinder closed.
3. Gas valve of heater not open.
1. Replace new gas cylinder.
2. Open the valve.
3. Attempt re-light sequence correctly.
Flame goes out while
heater is running.
1. Thermo-element was not heated
enough.
2. Safety thermostat activated.
3. Restricted air flow.
1. Repeat ignition process and keep safety gas valve
depressed for a minimum of 5 seconds, then release
slowly.
2. Allow the heater to cool down for at least 10
minutes. Check thermostat and the attempt re-light
sequence correctly.
3. Check heater inlet and outlet, remove any
obstructions.
SPECIFICATIONS
Rated voltage
220V-240V-50H
Rated output
80W
Heat output
70Mj/hr
Air flow
500m3/h
Gas consumption
1.42kg/h.
Weight (approx.)
8.5kg
Min gas cylinder size
15kg
Minimum volume of room
360m3