WHITECROFT LIGHTING Euroflood MidiLED Manual

GENERAL INFORMATION
1. A qualified electrician, in accordance with IEE wiring regulations,
should carry out connection to mains wiring.
2. Ensure mains power is turned off during maintenance.
3. Ensure that the rated voltage and frequency requirements are
compatible with the available mains supply.
4. Cleaning of reflectors and lenses should be carried out using
clean, soft and lint free cloths and anti-static cleaning fluid.
5. Do not carry out high voltage insulation test, i.e. 500/1000v this
may damage internal components.
6. LED version: Class 2 insulated and so does not require an earth
connection.
Conventional metal halide version: Class 1 insulated and must
Whitecroft Lighting Limited
Burlington Street, Ashton-under-Lyne, Lancashire OL7 0AX
Telephone [phone] Facsimile: [phone]
Registered No. 3848973 England Registered Office: As above
PK/LEAF/EUROMLED
TECHNICAL SUPPORT
Tel: [phone]
e-mail: [email protected]
www.whitecroftlighting.com
Euroflood MidiLED
Installation Leaflet
July2016 - Rev B
SPECIFICATION
Light Source Type: LED
Light Source Colour: 4000°K Ra 80 LED
Control Gear: Fixed output
Rating: IP66 / IK08
Product Colour: Graphite Grey
Body: Die-cast aluminium
Diffuser: UV-stabilised polycarbonate
Paint Finish: UV-stabilised coating
Power: 220-240V / 50-60Hz
Description Style Lumen Output Circuit Watts Weight (Kg)
EFLH14KG Slim Body 6030 52 6.3
EFLH24KG Slim Body 8528 81 6.3
EFLH34KG Slim Body 12452 121 6.3
EFLH44KG Slim Body 15595 169 6.3
173
140
10.5
164
Mounting Holes
The fixing centres for the luminaire are as
the the pole mount diagram.

LED INSTALLATION SEQUENCE
All measurements in mm unless stated otherwise
The LED version is class 2 insulated and does not require an earth connection.
Remove the fitting from all of the packaging.
1. Luminaire to be bolted to a suitable surface strong enough to take the loads
applied (Point 1).
2. Point of aiming (Point 2) to be done via main pivot bolt (Point 3) and fixing screw
(Point 4)
3. Fix the Live / Neutral conductors of the 2 core supply flex to the power connector
using the securing screws (Point 5).
4. Plug the power connector in the socket located at the bottom of the luminaire.
(Point 6).
5. Accessory EFLBKT76. Use the two bolts supplied to fix the luminaire to the pole
attachment. Clamp the attachment to the pole using the rear allen bolt.
6. Accessory EFLWG. Attach the wire guard to the front of the luminaire using the
four screws supplied.