TECHNICAL SUPPORT
Telephone: 0161 331 5700
E-mail: technical@whitecroftlight.com
http://www.whitecroftlighting.com/
Please note that this leaflet shows the installation process for both the small and
medium housing products. Any differentiation in the process will be highlighted.
1. Mount the unit to the wall using the diagram fig.1. Ensure that a suitable air gap between the
highest point of the luminaire and any features above is maintained. See fig. 2. Use suitable
mounting hardware.
2. To set the angle of the luminaire loosen the grub screw and then use a spanner to loosen
the nut. The luminaire will then freely pivot on the bracket. Once you have set the luminaire to
the desired angle tighten the nut with a spanner then tighten the grub screw to the torque
ratings as shown in fig.3. You may wish to set the angle before or after wiring the luminaire in
place. Note that you should not angle the luminaire greater than 100° off horizontal (fig.4).
3. To access the luminaire internals remove the 4
hex bolts from the upper section. The lower section
will come loose. Ensure you have hold of the lower
section as the two halves become disconnected as
fig 5.
Remove the internal terminal block cover if
required.
4. Wire the mains to the luminaire as per the images in fig.6. Feed through the mains
cable via the IP gland ensuring correct installation as to not compromise the integrity of
the product. Use a cable suitable for exterior use. The gland will accept wire with a
diameter between 9 and 12mm. This product is not suitable for through wiring.
5. To connect a DALI pair
to the internal LED driver
you will need to first
break an extra hole into
the luminaire housing
before using a suitable IP
gland and wire to the
terminal blocks as
specified in image 4.
6. Carefully reattach the
terminal block cover and
lower section (tighten
screws evenly) and
reinstate the mains
supply.
