Wholesale Interiors ALESHA User manual

STEP 1 STEP 2
STEP 3 STEP 4
ITEM : ALESHA - FB/QB
ASSEMBLY INSTRUCTION
QTY
1PC
PART LIST
NO
HEADBOARD
CUSHION
RIGHT HEADBOARD LEG
WITH 'R' LABEL
WINGS
FOOTBOARD
CUSHION
FOOTBOARD
LEGS
SIDE RAIL
SIDE RAIL
SIDE RAIL
SUPPORT LEG
QTY
HARDWARE LIST
NO
SUPPORT LEGS
WITH ADJUSTABLE FEET
SLATS
JCBC SCREW
M6 X 70
JCBC SCREW
M6 X 35
JCBC SCREW
M6 X 25
JCBB SCREW
M8 X 20
L - KEY
M5 X 65mm
SCREW
M4 X 32mm
FLAT WASHER
SPRING WASHER
WOOD DOWEL
LEFT HEADBOARD LEG
WITH 'L' LABEL
L - KEY
M4 X 65mm
1PC
1PC
1PC
1PC
1PC
2PCS
2PCS
2PCS
2PCS
2PCS
2PCS
2PCS
4PCS
4PCS
8PCS
8PCS
8PCS
20PCS
20PCS
16PCS
1
2
3
4
5
6
7
8
9
10
11
Make sure the cleat is
on outside edge
Do not fully tighten screws
until assembly is complete
and the bed is level
Do not fully tighten screws
until assembly is complete
and the bed is level
Begin assembly by attaching each headboard leg (2) & (3) to the
bottom of headboard cushion (1) by aligning the hole and securing with
3 Allen bolts (C), 3 spring washer (F), 3 flat washer (G) per leg using
L-key (J).
Attach the side rail support leg (9) to join of the side rail (7) &
side rail (8) by securing with 4 Allen bolts (B) , 4 spring washer (F) ,
4 flat washer (G) per support using L-key (J).
Attaching each wing (4) to each side of headboard cushion (1) by
aligning the hole and securing with 3 Allen bolts (C) , 3 spring
washer (F) , 3 flat washer (G) per side using L-key (J).
Attach each footboard legs (6) to the bottom of the footboard cushion
(5) by inserting a dowel (E) & securing with 1 Allen bolt (D) per leg
using L-key (J).

STEP 5 STEP 6
STEP 6.1
STEP 6.2
STEP 7
ASSEMBLY INSTRUCTION
Attach side rail to the headboard leg (2) & (3) & Footboard (5). Aligning holes and
securing with 2 Allen bolts (A) per each and using L-key (I). Do not tighten bolts for
this step.
Attach support legs (11) to slat (10) by securing with 1 Allen bolt (C) per support leg.
Attach slat (10) to side rail by securing with 1 screw (H) per each side. Tighten all screws
using philips head screw driver (NOT INCLUDED). Tighten all bolts on step 3 & 4
using L-key (J) & tighten bolts on step 5 using L-key (I).
NOTE : AFTER A FEW DAYS OF ASSEMBLY. IT WILL HAVE ACCLIMATIZED TO THE ENVIRONMENT. PLEASE TIGHTEN ALL HARDWARE.CHECK TIGHTNESS OF
ALL SREWS EVERY 6 - 8 WEEKS.