Wholesale Interiors BBT 6654 User manual

ASSEMBLY INSTRUCTIONS
MODEL : BBT 6654 FULL BED
STEP 1 STEP 2
1 of 3
HARDWARE LIST
ITEM DESCRIPTION QTY
1WOOD DOWEL M8 x 30mm 20 PCS
2JCBC BOLT M6 x 40mm 14 PCS
3 JCBC BOLT M6 x 70mm 4 PCS
4 JCBB BOLT M8 x 30mm 8 PCS
5JCBB BOLT M8 x 50mm 10 PCS
6M6 SPRING WASHER 8 PCS
7M6 FLAT WASHER 6 PCS
8M8 SPRING WASHER 10 PCS
9M8 FLAT WASHER 10 PCS
10 M4 ALLEN KEY (BALL SHAPE) 1 PC
11 M5 ALLEN KEY (BALL SHAPE) 1 PC
12 WOOD SCREW M3.5 x 16mm 8 PCS
13 WOOD SCREW M4 x 38mm 4 PCS
14 BED SLAT CENTER FITTER 12 PCS
15 BED SLAT SIDE FITTER 24 PCS
PART LIST
ITEM DESCRIPTION QTY
AHEADBOARD 1 PC
BHEADBOARD WING (L&R) 2 PCS
CHEADBOARD LEG (L&R) 2 PCS
DHEADBOARD SUPPORT WOOD 2 PCS
EHEADBOARD SUPPORT RAIL 1 PC
FFOOTBOARD 1 PC
GLEG 4 PCS
HAPRON 2 PCS
ISIDE APRON 2 PCS
JSIDE RAIL 2 PCS
KCENTER RAIL 1 PC
LCENTER SUPPORT LEG 3 PCS
MCENTER SUPPORT 2 PCS
NBED SLAT 24 PCS
6
2
10
1
1
1
G
I
L
K
B
6
2
10
H
G
I
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS : 1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.
Tool needed : Screwdriver & Hammer (not provider).

ASSEMBLY INSTRUCTIONS 2 of 3
STEP 3 STEP 4
STEP 5 STEP 6
11
11
8
9
5
4
11 58 9
Don't screw tied
Loosely fit bolt (4) into
Headboard Leg (C) picture down.
**Finish step 5,
Please screw tied the step 4 bolt.
10
3Loosely fit bolt (4) into Footboard (F) picture down.
4
F
A
C
D
E
J
C
F
13
C
x 2

ASSEMBLY INSTRUCTIONS 3 of 3
STEP 7 STEP 8
STEP 9
10
2
7
J
M
12
EK
15 N
14 N15
N
14
N
N
15
STEP (A)
STEP (B)
* When moving the bed position, the center support legs
must be adjust to be straight to avoid any broken problem.
STEP 10
B
STEP (A)
STEP (B)
Note: Assemble (M) vertically as picture shown