WilTec 61489 User manual

Operation Manual
12V, 17bar (250psi) Air Compressor
6148
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.

The information contained in this document may alter at any time without previous notice. It is prohib-
ited to copy or spread any parts of this document in any way without prior written allowance. ll rights
reserved.
The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this
operating manual, nor in the diagrams and figures shown.
Even though, the WilTec Wildanger Technik GmbH has undergone biggest possible efforts to ensure
that the operating manual is complete, faultless and up to date, mistakes cannot be entirely avoided.
If you should find a mistake or wish to make a suggestion for improvement, we look forward to hearing
from you.
Send an e-mail to:
[email protected]
or use our contact form:
https://www.wiltec.de/contacts/
The most recent version of this manual in various languages can be found in our online shop via:
https://www.wiltec.de/docsearch
Our postal address is:
WilTec Wildanger Technik GmbH
Königsbenden 12
52249 Eschweiler
Germany
Do you wish to pick goods up? Our pick-up address is:
WilTec Wildanger Technik GmbH
Königsbenden 28
52249 Eschweiler
Germany
To shorten the waiting time and allow for a rapid on-site transaction, we ask you to call us previously
or placing your order via the webshop.
E-mail: [email protected]
Tel:[phone]
Fax: [phone]
To return orders for exchange, repair or for other purposes, please use the following address. tten -
tion! To allow for a smooth execution of your complaint or return, it is important to contact our cus -
tomer service team before returning the goods.
Returns Department
WilTec Wildanger Technik GmbH
Königsbenden 28
52249 Eschweiler
E-mail: [email protected]
Tel:[phone]
Fax: [phone]
© by WilTec Wildanger Technik GmbH Item 61489 Page 2
http://www.WilTec.de
http://www.aoyue.eu 02 2021-1
http://www.teichtip.de

Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Operating instructions
•Do not run the compressor for more than 10=min at a time. If you need to use it for longer, turn
it off and let it rest for at least 10=min before starting it again.
•This compressor is not designed for inflating high pressure tires such as used on trucks, trail-
ers or tractors.
•When running at more than 3=bar (45=psi), do not operate the tool for more than 7=min.
•When using the compressor, never leave it unattended.
Inflating tyres
1. Move the vehicle so that the valve is in the bottom and its closest position to the ground. Place
the air compressor next to the tire.
2. Plug the power cord into the cigarette lighter receptacle.
3. Place connector on valve stem and firmly push down, close the thumb lash.
4. When the desired pressure is reached, unplug the power cord.
5. Remove adaptor from tire valve, remove the power cord from the cigarette lighter.
6. lways leave the thumb latch in the open position when storing the compressor.
Inflating other inflatable objects
Sports ad-
aptor
daptors for mattresses,
rubber boats, etc.
Lock valve stem connector
•Select the suitable adaptor and insert it into the connector. Close the thumb latch.
•Check the owner’s manual on the article to be inflated for the exact pressures.
•Insert the adaptor into the article to be inflated.
•Plug in the power cord into the cigarette lighter receptacle.
•When the desired pressure is reached, unplug the power cord.
•Remove the adaptor from the inflated article. Remove the adaptor from the connector. Re-
member to leave the thumb latch in opened position when storing it.
•lways check the item being inflated with the proper pressure gauge. void excessive pres-
sure on low pressure objects.
WARNING: void over-inflating. Never exceed the recommended pressure. Items being over-inflated
may burst and can cause serious injury.
© by WilTec Wildanger Technik GmbH Item 61489 Page 3
http://www.WilTec.de
http://www.aoyue.eu 02 2021-1
http://www.teichtip.de

Troubleshooting
Compressor does not start or blows fuses:
•Push the power plug firmly into the receptacle and twist it back and forth.
•Check receptacle and plug terminals for dirt. Use a non-conductive probe and no fingers or
metal to clear.
•Check lighter fuse. This should be 15= minimum.
•Check if the power cord is properly plugged in.
Compressor runs but does not inflate:
•Be sure the connector is on the valve stem as far as possible before closing the thumb latch.
•Check article for leaks.
•Check hose for breaks and leaks at fittings.
Compressor runs slowly:
•Overheated from excessive use. Unplug the power cord and leave the compressor to cool
down for at least 30=min.
•Voltage too low. Check condition of battery.
CAUTION
•This compressor is capable of inflating to 17=bar (250=psi). To avoid over inflation the user has
to strictly follow operating instructions as required and described. Do not exceed the recom-
mended pressure at any time. Never leave the unit unattended while operating it!
•The compressor should be kept out of reach of small children.
•Ensure that the connector is screwed into the valve stem until it looks firmly in place.
© by WilTec Wildanger Technik GmbH Item 61489 Page 4
http://www.WilTec.de
http://www.aoyue.eu 02 2021-1
http://www.teichtip.de

Disposal regulations
EU guidelines regarding the disposal of scrap electric appliances (WEEE, 2012/19/EU) were imple-
mented in the law related to electrical and electronic equipment and appliances.
ll WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out
wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the
domestic waste.
The company WilTec Technik GmbH has been registrated in the German registry E R under the
WEEE-registration number DE45283704.
Disposal of used electrical and electronic appliances
(intended for use in the countries of the European
Union and other European countries with a separate
collection system for these appliances).
The logo on the article or on its packaging points out
that this article must not be treated as normal house-
hold waste but must be disposed to a recycling collec-
tion point for electronic and electrical waste equip-
ment. By contributing to the correct disposal of this art-
icle you protect the environment and the health of your
fellow men. Environment and health are threatened by
inappropriate disposal.
Material recycling helps reduce the consumption of raw materials.
dditional information on recycling this article can be provided by your local community, municipal
waste disposal facilities or the store where you purchased the article.
ddress:
WilTec Wildanger Technik GmbH
Königsbenden 12 / 28
D-52249 Eschweiler
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH Item 61489 Page 5
http://www.WilTec.de
http://www.aoyue.eu 02 2021-1
http://www.teichtip.de