Wind Crest VEN060I User manual

© 2006 Wind Crest by CNP Industries 1
Install Quick Specs are for planning purposes only. Please refer to the detailed installation
instructions, prior to making any cutouts.
Internally Mounted Ventilators – Install Quick Specs
VEN060I
Installation Type & Discharge Direction
Mounted in hood. Can be mounted for vertical
or horizontal discharge, depending on the
hood specified (see individual hood
specifications)
CFM Rating
640 CFM – Single Blower
1280 CFM – Dual Blower applications
Minimum Duct Size
8” round @ 640 CFM
10” round @ 1280 CFM
Maximum Equivalent Straight Duct Length
50 feet
Equivalent Straight Lengths
•1 foot of 8” or 10” duct = 1 foot
•1 foot of 3 ¼” x 14” rectangular = 1 foot
•8” round 90 degree Elbow = 5 feet
•10” round 90 degree Elbow = 3 feet
•Wall or Roof Cap = 2 feet
Standard Features
•Adaptable to all Wind Crest hoods
•Brushed alumized steel construction
•Thermally protected, permanently
lubricated motor
•Dynamically balanced 5 ½” diameter
blower wheel
•Neoprene resilient anti-vibration mounted
•Low RPM for very quiet performance
•Two VEN060I internal blowers can be
mounted in the following hoods. This
requires a dual wire harness (part #10220).
oWSL and WCL hoods 48” or wider
oWER 60” wide hoods
oPSL 66” wide hoods
Ventilator Motor Ratings*
Hoods without Heat Lamps:
2.8 Amps @ 120 V AC, 60 Hz
Hoods with Heat Lamps:
7.2 Amps @ 120 V AC, 60 Hz
*For maximum power supply required, refer to
hood series selected.
Ventilator Carton Weight:
VEN060I = 23 lbs.
9 "
3/4
9 "
1/
4
14"
ULUL
LISTED7Z66 C
When installed in Wind Crest hoods
VEN060I

© 2006 Wind Crest by CNP Industries 2
Install Quick Specs are for planning purposes only. Please refer to the detailed installation
instructions, prior to making any cutouts.
Internally Mounted Ventilators – Install Quick Specs
Transitions Available
#10172 = 10” round Starting Collar
#10173 = 10” to 8” Round Adapter
#10288 = 8” Round Back draft Damper
#10289 = 10” Round Back draft Damper
#10542 = Plenum Transition to 10” round (use
with dual Internal or Remote blower on 48” and
larger WSL, WCL, WER60 or PSL66 hoods)
#10377 = 10” Round Rear Discharge
#10566 = 10” Round Left Side Discharge
#10378 = 10” Round Right Side Discharge
14 82
1
14 62
1
#10100 = 14” w X 4 ¼” d x 8 ½”h
Rectangular to 8” Round duct
#10287 = 14” w X 4 ¼” d x 8 ½”h
Rectangular to 10” Round duct
#10099 = 14 w x 4 ¼” d x 6 ½” h
Rectangular transition
10 4
1
52
1
10
8
7
11 ½” h x 32 ¾” w
11 ½” h x 14” w
11 ½” h x 16” w
11
½
” h x 16” w