Windsor Commodore 20 User manual

OPERATION
Commodore 20
WINDSOR
01)
Install jets and brush.
05) Pull lever to release brush
deck and turn vacuum on and
turn brush on.
04) Make sure that all three prongs are
on the main body of the cord. Ifone
of the prongs Is mIssIng, notIfy your su-
pervIsor ImmedIately.Plug in to outlet
and machine and twist to lock.
02)
Fill solution tank with extrac-
tion rinse or fresh water.
06) Choose speed. Use slower
speeds for deeper cleaning
and faster speeds for
lighter cleaning.
03)
Make sure that the handle is in the upright po-
sition and adjust the brush height by pushing
down on the vacuum shoe and turning the lever
and castle nut. Start at level 2 and adjust ac-
cordingly as brush wears. If the breaker trips,
back off on the pressure on the brush.
07)
Grab handle to engage the
brush and solution.

MAINTENANCE
Commodore 20
WINDSOR
01) Drain solution tank.
05) Clean oat shut off.
04) Clean mesh water lter and
water lter cap.
02)
Drain recovery tank.
06)
Remove jets and soak in a
solution of hot water and
vinegar overnight.
03)
Rinse out and clean recovery
tank.
07)
ToClean brush: remove vaccum
shoe, tilt the machine on its
right side, and hose off the
brushes.