Windsor SR-12 User manual

Windsor Industries
Upright Vacuum
Model Number: SR-12
Operating Instructions
Functions of the display (Figure 1)
Green light (a): Brush lowers.
Green light (b) : Brush raises
Red light (c): Continuous-change brush
Red light (c) : Flashing and motor off Brush jammed.
Clear brush.
Red light (c): Flashing and motor on (when machine
is upnght Position J-Take care: Brush
in contact with carpet.
Red light (d): Continuous change paper bag or clear
blockage.
Red light (d): Flashing - motor switched off due to
full paper bag or blockage.
On hard floors the adjustment wheel (41), moves upwards
into me machine so mat me brush becomes flush with me
floor. Therefore, the WINDSOR “SENSOR” can also be used
to vacuum hard floors. (Figure 2)
On carpeted floors the adjustment wheel (41) moves down-
wards out of the machine so that the brush rises. The adjust-
ment wheel (41) rises and lowers to adjust the brush to the
optimal setting. This combines effective. gentle brushing with
a smooth easy action. (Figure 3)
When the machine is switched on in the upright position
(Figure 4) the brush automatically rises from the carpet. To
release the machine from me upright position, press down the
foot pedal (18). The brush will automatically lower. The han-
dle can be lowered to an intermediate stop position in order
to lift up the brush head. To lower the handle to a horizontal
position the foot pedal must be pressed a second time. The
stop position can be closed off by a slider on the swivel neck
(19) so that the handle will go from vertical to horizontal in
one movement.
Figure 1
Hard Floor Surface
Carpeted Floor
Figure 2
Figure 3
Figure 4
abcd
(41) Adjustment
Wheel Moves Up
(41) Adjustment
Wheel Moves Down
18 19

To vacuum in corners etc., (Figure 5) take hold of the telescopic
handle grip. Lift it away from the machine and stretch out the hose.
After use insert the telescopic attachment tube into the back of the
machine. Raise the handle of the machine and the hose will automat-
ically retract. To use the hose without the tube as shown in the right
hand picture, the hose will pull out of the tube while the tube is fitted
to the machine. Alternatively, press the release catch (27) on picture
2 (see SR-12 Description - below).
To vacuum under beds (Figure 6) etc. the WINDSOR “SENSOR”
can be fitted with an additional straight tube and the floor nozzle.
The machine will then perform as a cylinder vacuum. Never run over
the cable with the brush/suction head.
Never run over the cable with the brush/suction head.
Always carry the machine over stairs and sills.
Figure 5
Figure 6
1. Handle grip
2. On/Off Swotch
3. Handle Assembly
4. Retaining Ring
5. Cover Release
6. Dust Bag Housing
7. Cover
8. Housing Release
9. Brush/Section Head
10. Cable
11. Telescopic Handle Grip
12. Hose
13. Carrying Handle
14. Cable Hook
15. Attachment Tube
16. Crevice Nozzle
17. Upholstery Nozzle
18. Foot pedal
20. Neck
21. Support Lever
22. Catch
24. Holder
26. Connecting Tube
27. Release Catch
SR-12 Description - 1
SR-12 Description - 2
Windsor Model SR-12 Description