Wine racks America KD-144 Series User manual

ASSEMBLY INSTRUCTIONS: KD-144,72,50 SERIES
COMPONENTS:
(1) Front Panel (1) Rear Panel (2) Side Support (8) Dome Nut (8) Elevator Bolt (2) Support
Hook
NOTE: WHEN ASSEMBLING THE RACK, DO NOT FIRMLY TIGHTEN BOLTS UNTIL THE RACK HAS BEEN LEVELED.

Figure1 Figure2
1. Locate the front panel and two side supports.
2. Place an elevator bolt through the side face of the front panel just below the second horizontal wire from the top. (Fig. 1)
3. Make sure the head of the elevator bolt is below the wire as shown. (Fig. 2)
Figure3 Figure4
4. Cover the treaded end of the elevator bolt with a dome nut, hand tight. (Fig. 3,4)
5. Repeat this procedure to connect the front panel to the bottom of the side supports for both sides.

Figure5 Figure6
6. At this point the rack should look like the photo shown above. (Fig. 5)
7. Locate the rear panel and place an elevator bolt through the side face of the front panel just below the third horizontal wire from the top. (Fig. 6)
8. Attach all four elevator bolts in the same manner as the front panel.
Figure7 Figure8
9. After all of the bolts have been inserted and loosely covered with the dome nuts, level the rack on the floor. Once the rack has been leveled, tighten
all of the dome nuts.
10. The rack should look like the photo above. (Fig. 7)

11. IMPORTANT: The two support hooks must be installed prior to loading the rack. Connect the support hooks from the front panel to the rear panel
at the third row from the top on the front and at the forth row near the middle of the rack as viewed from the front. (Fig. 8)
Note: WHEN PROPERLY ASSEMBLED BOTH THE FRONT AND REAR PANELS WILL SIT APPROXIMATELY 5 INCHES OFF THE
FLOOR. MAKE SURE ALL NUTS ARE MAINTAINED IN A TIGHT POSITION. FAILURE TO KEEP THESE TIGHT COULD RESULT IN
INJURY, DAMAGE TO THE RACK AND/OR PRODUCTS.